EGFR Gene Mutation and Methodological Evaluation in 399 Patients with Non-small Cell Lung Cancer

来源 :当代医学科学(英文) | 被引量 : 0次 | 上传用户:hlf00852
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The purpose of the present study was to study the characteristics of epidemic growth factor receptor(EGFR)gene distribution in patients with non-small cell lung cancer(NSCLC),and to detect the mutation rate of EGFR gene by Sanger sequencing and amplification refractory mutation system(ARMS)-PCR.Paraffin-embedded sections of NSCLC tissues from 399 NSCLC patients diagnosed in Renmin Hospital of Wuhan University were collected,103 of them were detected for exons 18-21 mutation of EGFR by Sanger sequencing method,296 cases were detected for exons 18-21 mutation by ARMS-PCR method.DNA extraction of both groups was performed with Qiagen QLAamp DNA FFPE Tissue KIT.Comparisons of detection rates between the two methods were conducted by row X list chi-square test.The total mutation rate of EGFR gene detected by Sanger sequencing was 21.4%,exons 18-21 and combined mutation rates were 1.0%,9.7%,1.0%,7.8%and 2.0%,respectively.And the proportions were 4.7%,45.2%,4.7%,36.3%and 9.4%respectively.The total mutation rate detected by ARMS-PCR was 51.4%,exons 18-21 and combined mutation rates were 2.7%,27%,1.7%,18.2%and 1.7%,respectively.The proportions were 5.3%,52.6%,3.3%,35.5%and 3.3%respectively.Further analysis of mutation rate showed that there was significant difference between the two methods in detecting total mutation of EGFR gene(P<0.001).There were significant differences in mutation detection rates of exons 19 and 21(P<0.001,P<0.05),but there were no significant differences in other exons.And there was no significant difference in mutation detection rates between the two methods.The mutation rate of EGFR gene in NSCLC patients was 50%.And exon 19 deletion was the most common mutation type,followed by exon 21 mutation.Compared with Sanger sequencing method,ARMS method is more sensitive with significant advantages in detecting exon 19 deletions and exon 21 mutations,which can be widely used in clinical detection of EGFR gene mutations.The results of this study will further guide patients with advanced NSCLC to select TKI targeted drugs,and provide clinical diagnostic basis for targeted therapy of NSCLC patients.
其他文献
采用磁控溅射的方式沉积不同Cr含量的Cu-Cr合金薄膜,通过与Sn-Ag-Cu(SAC)焊料在240℃下回焊形成焊点结构,然后将试样置于180℃下进行真空时效处理.研究Cu-Cr合金作为凸点下金属化(UBM)层时与SAC形成焊点的焊接可靠性.使用配备能量色散X射线光谱仪的场发射扫描电镜和多功能推力测试仪等分析界面金属间化合物(IMC)的形貌及焊点的剪切强度.结果表明,SAC/Cu-Cr焊点结构在回焊后形成了不同于传统的SAC/Cu焊点扇贝状IMC的针状IMC.在时效处理后,Cr在晶界处的偏析形成了富铬层,
采用固体渗硼工艺对65Mn钢进行渗硼处理,并借助光学显微镜、X射线衍射仪、电子探针及维氏硬度计等手段系统研究了渗硼温度(800~1000℃)和渗硼保温时间(2~8 h)对65Mn钢渗硼层厚度、微观组织和硬度的影响规律以及渗硼层的生长动力学.结果表明,随着渗硼温度的升高或渗硼时间的延长,渗硼层的厚度不断增大,但当渗硼温度超过900℃时,渗硼层中黑色孔洞的数量、大小以及距离渗硼层表面的深度都逐渐增大.65Mn钢渗硼层都由Fe2 B柱状晶,以及位于Fe2 B柱状晶生长前沿及晶粒间的Fe3(B,C)相、二元铁硅化
The incidence of colorectal cancer(CRC)is increasing in China,with high mortality.Here,we aimed to evaluate the latest clinicopathological features and prognostic value of the KRAS/NRAS/BRAF mutation status in CRC patients in Central China.The clinical da
Amyloid beta (Aβ) peptide 40 enhances the activation of receptor for advanced glycation end products (RAGE) in immune-inflammatory diseases.RAGE exhibits several effects in the setting of numerous cardiovascular events.We hypothesized that the Aβ40/RAGE p
Angiopoietin-like protein 2(ANGPTL2)stimulates inflammation and is important in the pathogenesis of diabetic kidney disease(DKD).Irbesartan is helpful in reducing diabetes-induced renal damage.In this study,the effects of irbesartan on DKD and its renal p
Given the rapid increase in the prevalence of chronic diseases in aging populations,this prospective study including 17 707 adults aged ≥45 years from China Health and Retirement Longitudinal Study was used to estimate the associations between chronic dis
通过微弧氧化技术(Micro-arc oxidation,MAO)对TC4合金进行表面处理,探究了不同MAO电压对TC4合金氧化膜层摩擦磨损性能的影响.使用激光共聚焦显微镜、扫描电镜、X射线衍射仪、显微硬度计及高温真空摩擦磨损试验仪对膜层形貌、相成分、硬度以及摩擦学性能进行了测试.结果表明:随着MAO工作电压的升高,MAO-TC4合金表面膜层中锐钛矿型TiO2和金红石型TiO2的含量随之增加,其表面粗糙度、显微硬度以及平均摩擦因数亦随之增大,磨损率先降低后增大.当MAO工作电压为280 V时,磨损率最小,
以45钢为基材,通过放电等离子烧结和铸造工艺成功制备了WC颗粒增强表层复合材料,研究不同浇铸工艺参数对表层WC/Fe复合材料与基材之间的界面结合及微观组织的影响.结果表明:随着浇铸量的增加,锭模的数值模拟温度可达1493℃,高温停留时间约734 s,为实现钢液与WC/Fe复合材料冶金结合提供有利条件,但是过高的浇铸量使WC/Fe复合材料的组织发生明显的变化,几乎观察不到WC增强相,组织出现大量鱼骨状碳化物Fe3 W3 C.当浇铸量控制在锭模体积的2/5时,可得到良好的WC/Fe复合材料与基材的宏观界面,界
Although the exact etiology of inflammatory bowel disease (IBD) remains unclear,exaggerated immune response in genetically predisposed individuals has been reported.Thl and Th17 cells mediate IBD development.Macrophages produce IL-12 and IL-23 that share
Peripheral T-cell lymphoma (PTCL) is a very aggressive and heterogeneous hematological malignancy and has no effective targeted therapy.The molecular pathogenesis of PTCL remains unknown.In this study,we chose the gene expression profile of GSE6338 from t