Under hypersonic flight conditions,the sharp cowl-lip leading edges have to be blunted because of the severe aerodynamic heating.This paper proposes four cowl-lip blunting methods and studies the corresponding flow characteristics and performances of the generic hypersonic inlets by numerical simulation under the design conditions of a flight Mach number of 6 and an altitude of 26 km.The results show that the local shock interference patterns in the vicinity of the blunted cowl-lips have a substantial influence on the flow characteristics of the hypersonic inlets even though the blunting radius is very small,which contribute to a pronounced degradation of the inlet performance.The Equal Length blunting Manner(ELM)is the most optimal in that a nearly even reflection of the ramp shock produces an approximately straight and weak cowl reflection shock.The minimal total pressure loss,the lowest cowl drag,maximum mass-capture and the minimal aeroheating are achieved for the hypersonic inlet.For the other blunting manners,the ramp shock cannot reflect evenly and produces more curved cowl reflection shock.The Type V shock interference pattern occurs for the Cross Section Cutting blunting Manner(CSCM)and the strongest cowl reflection shock gives rise to the largest flow loss and drag.The cowl-lip blunted by the other two blunting manners is subjected to the shock interference pattern that transits with an increase in the blunting radius.Accordingly,the peak heat flux does not fall monotonously with the blunting radius increasing.Moreover,the cowl-lip surface suffers from severe aerothermal load when the shear layer or the supersonic jet impinges on the wall. Under hypersonic flight conditions, the sharp cowl-lip leading edges have to be blunted because of the severe aerodynamic heating. This paper proposes four cowl-lip blunting methods and studies the corresponding flow characteristics and performances of the generic hypersonic inlets by numerical simulation under the design conditions of a flight Mach number of 6 and an altitude of 26 km. results show that the local shock interference patterns in the vicinity of the blunted cowl-lips have a substantial influence on the flow characteristics of the hypersonic inlets even though the blunting radius is very small, which contribute to a pronounced degradation of the inlet performance. The Equal Length blunting Manner (ELM) is the most optimal in that a nearly even reflection of the ramp shock produces an approximately straight and weak cowl reflection shock. minimal total pressure loss, the lowest cowl drag, maximum mass-capture and the minimal aeroheating are achieved for the hypersonic inlet. For the other blunting manners, the ramp shock can not reflect evenly and produce more curved cowl reflection shock. The Type V shock interference pattern occurs for the Cross Section Cutting blunting manner (CSCM) and the strongest cowl reflection shock gives rise to the largest flow loss and drag.The cowl-lip blunted by the other two blunting manners is subjected to the shock interference pattern that transits with an increase in the blunting radius. Accordially, the peak heat flux does not fall monotonously with the blunting radius increase. Moreover, the cowl-lip surface suffers from severe aerothermal load when the shear layer or the supersonic jet impinges on the wall.