十一、工件快速推送装置1.机构概述当工件的形状和加工周期不同时,输送工件的速度也必有差异,如图11所示。在下一工序中,由于滚式输送道较长,所以需要高速度推出工件,从而缩短输送时间。本装置由皮带式输送机、滚式输送机和推送气缸构成。气缸的机械装置如图11(a)所示,为防止活塞杆转动,而设置导杆。对所用的气缸应有下列要求:(1)宜使用适应高速的密封元件(如活塞环、聚四氟乙烯密封圈等); Eleven, the workpiece quickly push device 1. Mechanism Overview When the workpiece shape and processing cycle is different, the speed of the workpiece must be different, as shown in Figure 11. In the next process, because the roller conveyor is long, the workpiece needs to be pushed out at a high speed, thereby shortening the conveying time. The device consists of belt conveyor, roller conveyor and push cylinder. As shown in Figure 11 (a), the cylinder mechanism is provided with a guide rod to prevent the piston rod from rotating. The cylinder should be used for the following requirements: (1) should be used to adapt to high-speed sealing components (such as piston rings, Teflon seals, etc.);