图示的高频炉感应加热通用夹座我厂已使用七年多,它具有更换感应器方便,并能自动接通和关闭冷却水;元宝螺丝压紧接触导电可靠等优点,但还存在着紫铜螺纹易磨损;大功率长时间工作时元宝螺丝冷却不足,温度较高,等问题,如制做时建议将上图冷却水管移至前端,以避免冷却水流死角。在感应器未放入前,在进水压力的作用下,零件13铜球与φ9橡胶管压紧密封。当感应器插入后把铜球顶向右面,使水进入感应器。为了减轻感应器插入时的阻力,在感应器进水端倒一缺口,使感应器顶着铜球后使水泄漏 I have used the factory induction heater for more than seven years, it has the convenience of replacing the sensor, and can automatically turn on and off the cooling water; ingot screw pressed contact with conductive and reliable, but there are still Copper thread easy to wear; power long working hours when the ingot screw cooling, high temperature, and other issues, such as the system is proposed to be moved to the front of the cooling pipe to the front, in order to avoid the dead ends of the cooling water. In the sensor is not put before, under the action of the water pressure, the part 13 copper ball and φ9 rubber tube pressure tight seal. When the sensor is inserted, push the copper ball to the right and make the water enter the sensor. In order to reduce the resistance when the sensor is inserted, an indentation is poured on the water inlet end of the sensor so that the water leaks when the sensor is pushed against the copper ball