Salt-washing Improvement of the Electrochemical Properties of Zeolite-sulfur Cathode for Lithium-sul

来源 :武汉理工大学学报(材料科学版)(英文版) | 被引量 : 0次 | 上传用户:s04325102
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
We displayed that the low-cost natural zeolite with molecular sieve structure can be used as the carrier of sulfur in lithium-sulfur batteries. Meanwhile, a simple salt-washing method was implemented on zeolite for dredging the internal microchannel to improve the ability of adsorption, ion exchange and sulfur loading. The experimental results show that the first specific discharge capacities of zeolite/S and salt-washed zeolite/S cathode under 0.2 C current density are 950.7 and 1116.8 mAh/g, respectively, and corresponding discharge capacities remain at 350.6 and 604.2 mAh/g after 300 cycles. The first specific discharge capacity of salt-washed zeolite/S composite is 17.5% higher than that sample without salt-washing, and the corresponding ionic conductivity is improved.
其他文献
Frequency-doubled antireflection coatings simultaneously effective at 1064 nm and 532 nm were deposited on the lithium triborate(LiB_3O_5 or LBO)crystals using the electron beam evaporation method.Comparing with the sample without buffer layer,it is found
High-energy shot peening(HESP),a method to produce severe plastic deformation by high velocity flying balls,was applied on die cast magnesium alloy AZ91D.Effects of surface nanocrystallization by HESP and heat treatment at different temperatures were inve
Titanium dioxide(TiO_2)porous ceramic pellets with three dimension nano-structure were prepared using nano TiO_2 powder.The TiO_2 porous ceramic pellets were composed of TiO_2 nanoparticles with 14-16 nm in diameter and had porosity of 74.85%.The mean por
Ca_xBa_(1-x)TiO_3(CBT)fine particles doped with red luminescence center of Pr~(3+)ions (Pr:CBT)were successfully synthesized by salt assisted spray pyrolysis(SASP)process.Scanning electronic microscope(SEM)and laser scattering analysis demonstrate that sa
Effects of operating parameters in the thermal gradient chemical vapor infiltration of propane such as thermal gradient, diffusion, infiltrations time, and concentration of propane were studied by focusing on the visualizations of the intrinsic effects of
Al-doped ZnO (AZO) powders were prepared by using metal chloride precursors and the sol-gel technique. IR peaks observed at 1590 cm-1 and 1620 cm-1 indicated the formation of metal chelate as a consequence of the addition of acetylacetone to the metal chl
A novel cationic photosensitive resin (3DSLR-01) for stereolithography 3D printing was prepared with 3,4-epoxycyclohexylmethyl-3\',4\'-epoxycyclohexane carboxylate (2021P),1,4-cyclohexanedimethanol glycidyl ether (JX-026),diglycidyl 4,5-epoxycyclohexa