Study on Properties of LSGM Electrolyte Made by Tape Casting Method and Applications in SOFC

来源 :稀土学报(英文版) | 被引量 : 0次 | 上传用户:Monking
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Solid oxide fuel cell is attracting more attention in recent years for its lower pollution emission and high energy convert efficiency. La0.9Sr0.1Ga0.8Mg0.2O3-δ is a new kind of electrolyte for intermediate temperature SOFC. In this paper, La0.9Sr0.1Ga0.8Mg0.2O3-δ (LSGM) was prepared by solid state reaction method and formed by tape casting process to make a planar electrolyte. The appropriate amount of the dispersive was obtained by viscosity test. The densities of sintered samples increase with the increasing sintering temperature. It was found that the relative density of electrolyte can approach the value of 95% by the isostatic pressing treatment of the green tape. The average thermal expansion coefficient of the LSGM is 11.4×10-6/℃ at temperature range (200~1200 ℃). Measurements of the current-voltage and power-current characteristics of the H2-Air cell show that the open-circuit voltage is 1.067 V at 800 ℃, peak current density is 0.56 A·cm-2 and the maximum power output is 0.147 W·cm-2.
其他文献
2195 aluminum-lithium alloy was widely applied in the aviation and aerospace industry, but it is highly susceptible to pitting and intergranular corrosion under
A quantitative study about the thermal activation of thermal donors (TD) in high resistivity magnetic Czochralski (MCz) silicon was carried out. The samples are
Rare earth composite materials radiating far-infrared rays were prepared according to far infrared absorption spectrum of main component in liquefied petroleum
Diamond-like carbon (DLC) films were prepared by PLD process using 308 nm(XeCl) laser beam with high power (500 W) and high frequency(300 Hz). The effects of ni
In order to improve the strip quality of continuous roll-casting process (CRP) of aluminum alloy, the investigations of the flow behavior within the metal pool,
Distribution of localized damage in shear band can t be predicted theoretically based on classical elastoplastic theory. The average damage variable in shear ba
Employing isothermal and isochronal differential scanning calorimetry, an analytical phase transformation model was used to study the kinetics of crystallizatio
The packaging poses a critical challenge for commercialization of MEMS products. Major problems with the packaging process include degraded reliability caused b
The precursor precipitation of InVO4 was synthesized by co-precipitation using indium trichloride (InCl3),ammonium metavanadate (NH4VO3) and ammonia (NH3-H2O) a
Ferroelectric devices are widely applied in many fields, such as energy conversion and communication. The aging effect in ferroelectric materials plays a centra