【摘 要】
:
The structure and electrochemical properties of the La0.7Mg0.3Ni3.4-xMn0.1Cox (x=0-1.05) hydrogen storage alloys were investigated. The crystal structure and th
【机 构】
:
Department of Materials Science and Engineering
论文部分内容阅读
The structure and electrochemical properties of the La0.7Mg0.3Ni3.4-xMn0.1Cox (x=0-1.05) hydrogen storage alloys were investigated. The crystal structure and the lattice parameters of the alloys were analyzed by X-ray diffractometry and Rietveld method. Electrochemical properties of the alloys including p-c-t curves, discharge capacity, discharge capacity retention were studied. The results show that (La, Mg)Ni3 and LaNi5 are the main phases of all the alloys. The plateau pressure for hydrogen absorption/desorption decreases and the hydrogen storage capacity firstly increases and subsequently decreases with increasing Co content. The values of the maximum discharge capacity of the alloy electrodes remain in range of 395.3-403.1mA·h/g in spite of the change of Co content. The cycling stability of the alloy electrodes is greatly improved with increasing Co content, which is attributed to the suppression of the cell volume expansion during hydriding, leading the pulverization of the alloy particles lowered and the oxidation/corrosion of the active elements reduced.
其他文献
MoS2 coatings were prepared by unbalanced bipolar DC magnetron sputtering under different argon pressures and for different deposition times, and the structure
Nominal composition of Ca1 - xZnxTiO3: 0. 002Pr3 + ( x = 0. 000 ~ 0. 200) phosphors were prepared by conventional solid reaction route. XRD and PL measurements w
Through the differentiating and integrating process, a mathematical model for tempering time effect on quenched steel was derived based on the attribute of stat
Application of amorphous V2O5/carbon/neodymium oxide (Nd2O3) composite is one of ways to surmount the lower electrical conductivity of V2O5. A new type of V2O5/
The variations of electrical conductivity and hardness across the thickness of an Al alloy 7010 plate under the temper condition T7651 were investigated. The el
The joining of graphite, ceramic SiC and Cf/SiC composites via preceramic silicone resin(SR) at high temperature (800-1400℃) was studied. The curing and pyroly
An attempt has been made to study the influence of wear parameters like applied load, sliding speed, sliding distance and percentage of reinforcement on the dry
Oil-air two-phase flow measurement was investigated with a Venturi and void fraction meters in this work. This paper proposes a new flow rate measurement correl
Allylsucrose has been prepared by reaction of sucrose with allyl chloride in the NaOH-DMSO system.DS (average degree of substitution) of allylsucrose calculated
WC(27%) reinforced steel matrix composites were produced by using an electroslag melting casting technique. The microstructure of the material was characterized