论文部分内容阅读
一土建方面 (1)地板問題。电鍍車間为含酸、碱、水和湿度大的車間,如地板不良,在严重時將使車問停止生产。目前,已經有几个自行設計的工厂因地板質量的影响,發生了返工甚至停工現象。小組討論認为:地板为四层才能合乎要求;底层为水泥坪或水泥楼板,次为煤渣混凝土,上面铺油毛氈,然后铺耐酸水泥,最上面铺磁磚(馬赛克或15公厘厚的磁磚,或上釉缸磚)。另外也可用水泥地坪上铺混凝土,次鋪油毛氈,上鋪瀝青混凝土(砂漿),再鋪瀝青瑪璃脂,最上层为磁磚(15公厘厚的)。
A civil engineering aspect (1) floor problems. The electroplating workshop is a workshop with acid, alkali, water, and high humidity. If the floor is bad, it will stop the production of vehicles in serious situations. At present, there have been several self-designed factories that have experienced rework or even shutdown due to the impact of the floor quality. According to the panel discussion, four floors are required to meet the requirements; the bottom floor is cement or concrete floor slabs, followed by cinder concrete, topped with oil-filled felt, then acid-resistant concrete, top-most tiled tiles (mosaic or 15 mm thick tiles) , or glazing bricks). In addition, concrete floor can also be used for laying concrete, sub-paving oil felt, laying asphalt concrete (mortar), asphalting glass marble, and the uppermost layer is tile (15 cm thick).