【摘 要】
：
The dynamic strain aging behavior during tensile tests of K40S alloy has been investigated in the temperature range of 25-1100℃ with the strain rate range from
【机 构】
：
Institute of Metal Research
论文部分内容阅读
The dynamic strain aging behavior during tensile tests of K40S alloy has been investigated in the temperature range of 25-1100℃ with the strain rate range from 10-4to 10-3 s-1. The results show that four different types of serration, identified as A,B, C and E type serration were observed in the temperature range of 300-600℃. The strain exponents for onset of the serrated flow were calculated as 1.21, 2. 79 and 1.61,and the activation energies as 121, 40 and 67kJ/mol for E, B and C type serration respectively. The main mechanism for dynamic strain aging discussed in light of the strain exponent and the activation energy.
其他文献
This paper proposes a polynomial-time algorithm for Minimum WDM/SONET Add/Drop Multiplexer Problem (MADM) on WDM directed fiber trees whether or not wavelength
By considering that the coherent structure is the main cause of the Reynolds stress, a new Reynolds stress expression was given. On this basis the velocity dist
This paper addresses the problem of fault-tolerant multicast routing in wormholerouted multicomputers. A new pseudo-cycle-based routing method is presented for
The influence of tin on the hot ductility of a 0. 15wt%C steel is investigated using a continuous-casting thermal simulator with three cooling rates. Tin can ap
By using of electrolytic pure iron, the specimens containing different oxide content were made in a Mo wire furnace. The DTA method was employed to measure the
用纳米ZnO为原料,以魔芋葡甘聚糖(KGM)为基体,采用共混法制得KGM/ZnO纳米复合物。通过傅立叶红外光谱(FTIR)、热重分析(TG)、透射电镜(TEM)等手段对该体系进行了表征。结果表
This paper presents an approach for camera auto-calibration from uncalibrated video sequences taken by a hand-held camera. The novelty of this approach lies in
The cyclic voltametry and potentiostatic electrolysis was used to investigate the preparation of Bi-Fe alloy films in LiClO4-DMSO (dimethylsulfoxide) system. Th
Work in inductive learning has mostly been concentrated on classifying. However,there are many applications in which it is desirable to order rather than to cla
本文针对工业过程中的不稳定及纯滞后对象 ,采用分步设计方法 ,首先利用多项式拟合纯滞后环节 ,进而构造内环状态反馈改善对象动态特性 ;再对闭环系统按照极点配置原则 ,整定