论文部分内容阅读
1.风机的选择和安装GC31型电机的风机装在传动端,电机总装后检查风机的风压和风量是否达到设计要求,由检验科进行这项试验,合格后装上去。若达不到要求,调换叶轮。若反压力太高,即叶轮小。或调换电机,如果换了也无用,就调换叶轮。用测试风道测量每种叶轮供给的风量和风压。风量是电磁设计部门计算后提出,所需的风量和风压同样都应满足
1. Fan Selection and Installation GC31-type fan motor installed in the transmission side, after the assembly of the motor to check the wind turbine air pressure and air volume to meet the design requirements of the test conducted by the Department, after passing up. If you can not meet the requirements, replace the impeller. If the back pressure is too high, the impeller is small. Or change the motor, if the change is useless, to replace the impeller. Measure the air volume and air pressure supplied by each impeller with the test air duct. Air volume is calculated by the electromagnetic design department, the required air volume and wind pressure should also be met