【摘 要】
:
To improve the effect of destroying time-sensitive target (TST), a method of operational effectiveness evaluation is presented and some influential factors are
论文部分内容阅读
To improve the effect of destroying time-sensitive target (TST), a method of operational effectiveness evaluation is presented and some influential factors are analyzed based on the combat flow of system for destroying TST. Considering the possible operation modes of the system, a waved operation mode and a continuous operation mode are put forward at first. At the same time, some relative formulas are modified. In examples, the influential factors and operation modes are analyzed based on the system effectiveness. From simulation results, some design and operation strategies of the system for destroying time sensitive targets are concluded, which benefit to the improvement of the system effectiveness.
其他文献
The simplified transfer function diagram block for a monitor automatic gauge control (Mon-AGC) system of strip steel rolling process was investigated. The new n
In order to increase the understanding of the pyrolysis mechanism,Fourier transform infrared spectroscopy (FT-IR) and thermogravimetry-mass spectrometric coupli
A new kind of problem for TVC vehicle spinning in the boost stage had been researched.The study of non-linear flying dynamics modeling and dynamic properties of
Precursor pastes were obtained by milling Cu-In alloys and Se powders.CuInSe2 thin films were successfully prepared by precursor layers,which were coated using
The convergence and stability analysis for two end-to-end rate-based congestion control algorithms with unavoidable random loss in packets are presented,which c
Knowledge discovery from data directly can hardly avoid the fact that it is biased towards the collected experimental data, whereas, expert systems are always b
A global asymptotic stability problem of cellular neural networks with delay is investigated.A new stability condition is presented based on the Lyapunov-Krasov
A new type of lead-based porous anode in zinc electrowinning was prepared by negative pressure infiltration.The anodie polarization potential and corrosion rate
The electroslag remelting (ESR) layer reinforced by TiC particles was obtained by electroslag remelting. The microstruc-ture and wear properties of the ESR laye
Hydrous ruthenium oxide was formed by a new process. The precursor was obtained by mixing the aqueous solutions of RuCl3·xH2O and NaHCO3. The addition of NaHCO