Distribution of Electrical Field Energy for Conversion of Methane to C2 Hydrocarbons via Dissymmetri

来源 :天然气化学(英文版) | 被引量 : 0次 | 上传用户:emydisk
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Direct conversion of methane into C2 hydrocarbons through alternating current electric field enhanced plasma was studied under room temperature, atmospheric pressure and low power conditions.The distribution of electrical field intensity and distribution of energy were calculated with software that was developed by us according to the charge simulation method. The results indicated that the energy of tip of electrode was 0.36 J/mm3 and it was higher than the methane dissociation energy (0.0553 J/mm3).The methane located at this area can be activated easily. The higher-energy particles produced by dissociation collided with molecules around them and initiated consecutive reactions between free radicals and molecules. The method was proved to be valided and could be taken as a basis for the electrical field study concerned.
其他文献
介绍了有限体积数值方法,该方法适用于在任意非结构网格上求解线性和非线性的航空声学问题.本方法基于角点-中心的多参数格式,可在笛卡尔网格上达到六阶精度,对于可能的不连
平朔公司安太堡三号井工矿2007年3月在首采工作面辅运顺槽掘进时,迎头冒顶突水,初期突水量达6000~8000m3/d,将1 289.16m标高以下淹没.在分析研究区地层、构造及水文地质条件的
Depolymerization of poly(ethylene terephthalate) (PET) was performed in the tubular bomb microreactor which contained the solution of PET in methanol and dibuty
CFD验证和确认是气动计算可信度分析的基本活动.通过这类活动将产生大量数据资源.如何有效管理和利用这些数据资源是基准数据库要解决的主要问题.研究并提出了一种可行的共享
Multi-project multi-site location problems are multi-objective combinational optimization ones with discrete variables which are hard to solve. To do so, the ca
德国在若干年前启动的国家CFD项目MEGAFLOW集中了DLR、大学以及航空工业界的许多CFD研究开发工作,目的是开发并验证能满足工业实践所要求的可靠并有效的数值工具,以对全机进
A fast, matrix-free implicit method based on the Lower-Upper Symmetric Gauss-Seidel (LU-SGS) method was developed to solve the three-dimensional incompressible
给出了两种不同的再入飞行器:充气的再入和下滑演示器(IRDT)和Huygens.两者的任务都涉及在靠近轨道的条件下再入并均已于2005年完成.概述了IRDT的使命和具体设计问题,综述了I
Numerical simulations of 3D turbulent flow in a large-bore axial-flow pump coupled with half-elbow suction sump were performed by using CFD approach. The numeri