【摘 要】
:
Fouling-resistant ceramic-supported polymer composite membranes were developed for removal of oil-in-water (O/W) microemulsions. The composite membranes were fe
【机 构】
:
School of Chemical Engineering
论文部分内容阅读
Fouling-resistant ceramic-supported polymer composite membranes were developed for removal of oil-in-water (O/W) microemulsions. The composite membranes were featured with an asymmetric three-layer structure,i.e., a porous ceramic membrane substrate, a polyvinylidene fluoride (PVDF) ultrafiltration sub-layer, and a polyamide/polyvinyl alcohol (PVA) composite thin top-layer. The PVDF polymer was cast onto the tubular porous ceramic membranes with an immersion precipitation method, and the polyamide/PVA composite thin top-layer was fabricated with an interfacial polymerization method. The effects of the sub-layer composition and the recipe in the interfacial polymerization for fabricating the top-layer on the structure and performance of composite membranes were systematically investigated. The prepared composite membranes showed a good performance for treating the O/W microemulsions with a mean diameter of about 2.4μm. At the operating pressure of 0.4MPa, the hydraulic permeability remained steadily about 190L·m-2·h-1, the oil concentration in the permeate was less than 1.6mg. L-1, and the oil rejection coefficient was always higher than 98.5% throughout the operation from the beginning.
其他文献
The thick and hard ceramic coatings were deposited on 2024 Al alloy by microarc oxidation in the electrolytic solution.Microstructure, phase composition and wea
Computer simulation for materials processing needs a huge database containing a great deal of various physical properties of materials. In order to employ the a
A stochastic model for simulating the microstructure formation of Mg alloy AZ91 during solidification was developed based on the finite element method(FEM) for
The assessment for bearing capacity of corroded RC members is one of the main component of durability study on RC structure. But few researches had been develop
La doped nanocrystalline TiO2 photocatalyst was developed by sol-gel method. The prepared La-TiO2 photocatalysts with anatase phases were characterized by X-ray
Computational studies of a class of potentially stable high-spin biradicals that two-atom-three-electron spin centers SC units connected by heterocycles FC and
The compressive experiments of two kinds of ceramic foams were completed. The results show that the behavior of ceramic foams made by organic filling method is
In order to improve the prediction capability of spring-back in aluminum sheet metal forming, the influence of the plastic deformation on elastic modulus is con
The ceramic coating formed on AZ91 magnesium alloy by micro-arc oxidation (MAO) was characterized. The results show that the ceramic coating(3.4-23 μm in thick
By electrical resistance tomography (ERT) the cross sectional profiles of gas hold-up in a φ56mm bubble colunmn are obtained with four designs of gas sparger.