The diode-triggered silicon-controlled rectifier(DTSCR) is widely used for electrostatic discharge(ESD) protection in advanced CMOS process owing to its advantages, such as design simplification, adjustable trigger/holding voltage, low parasitic capacitance. However, the multiple-triggering effect in the typical DTSCR device may cause undesirable larger overall trigger voltage, which results in a reduced ESD safe margin. In previous research, the major cause is attributed to the higher current level required in the intrinsic SCR. The related discussions indicate that it seems to result from the current division rule between the intrinsic and parasitic SCR formed in the triggering process. In this letter, inserting a large space into the trigger diodes is proposed to get a deeper insight into this issue. The triggering current is observed to be regularly reduced along with the increased space, which confirms that the current division is determined by the parasitic resistance distributed between the intrinsic and parasitic SCR paths. The theoretical analysis is well confirmed by device simulation and transmission line pulse(TLP) test results. The reduced overall trigger voltage is achieved in the modified DTSCR structures due to the comprehensive result of the parasitic resistance vs triggering current, which indicates a minimized multipletriggering effect. The diode-triggered silicon-controlled rectifier (DTSCR) is widely used for electrostatic discharge (ESD) protection in advanced CMOS process due to its advantages, such as the design simplification, adjustable trigger / holding voltage, low parasitic capacitance. However, the multiple- triggering effect in the typical DTSCR device may cause increased risk in excessively small overall trigger voltage, which results in a reduced ESD safe margin. seems to result from the current division rule between the intrinsic and parasitic SCR formed in the triggering process. In this letter, inserting a large space into the trigger diode is proposed to get a deep space into the triggering process. regularly reduced along with the increased space, which confirms that the current division is determined by the parasitic resistance distributed The intrinsic analysis and transmission line pulse (TLP) test results. The reduced overall trigger voltage is achieved in the modified DTSCR structures due to the complete result of the parasitic resistance vs triggering current, which indicates a minimized multiple triggering effect.