【摘 要】
：
CuO was synthesized by thermal decomposition of Cu(NO3)2·3H2O at various temperatures and characterized by powder X-ray diffractometry (XRD) as well as scannin
【机 构】
：
School of Chemistry and Chemical Engineering,Department of Chemistry and Chemical Engineering
论文部分内容阅读
CuO was synthesized by thermal decomposition of Cu(NO3)2·3H2O at various temperatures and characterized by powder X-ray diffractometry (XRD) as well as scanning electron microscopy (SEM). The effects of calcination temperature, category of sacrificial reagent, initial sacrificial reagent concentration, and Ag loading content on the photocatalytic activity of the as-obtained CuO sample were investigated. The results show that the as-obtained CuO exhibits high activity for photocatalysis of H2 evolution reaction (HER) in oxalic acid solution under simulated sunlight irradiation. The highest photocatalytic activity of the as-obtained CuO was achieved at the calcination temperature of 1 000 °C, and oxalic acid was used as the sacrificial reagent with the concentration 0.05 mol/L. H2 evolution rate is as high as 2.98 mmol/(h·g) with 2% (mass fraction) loaded Ag. The possible photocatalytic reaction mechanism on the CuO photocatalyst for HER in oxalic acid solution was also discussed.
其他文献
艺术设计教育的目的是培养符合社会需求、满足人们需要，具有创新精神与实践能力的高素质的复合型设计人才。由于我国正处在社会主义市场经济高速发展时期，经济的发展呼唤着设计
采用固体超强酸SO_4~(2-)/TiO_2-Fe_2O_3为光催化剂,苯酚的光催化降解为模型反应,考察了pH值、苯酚初始浓度、催化剂投加量、光照距离、光照时间、助催化剂H_2O_2对光催化降
为了对某电厂灰渣库运行情况进行安全性评价,通过综合分析灰渣坝库区地形地貌、地层岩性、水文地质条件及灰渣坝现状,采用数值模拟方法对储灰场边坡的稳定性进行了分析,结果
A series of hydrogen storage Co-free AB3-type alloys were directly synthesized with vacuum mid-frequency melting method, within which Ni of La0.7Mg0.3Ni3 alloy
The effects of temperature on atomic anti-site behaviors in L12-Ni3(AlFe) phases were studied using microscopic phase-field dynamic model in precipitation progr
1-butyl-3-methylimidazolium perchlorate ([BMIM]ClO4) was synthesized by two steps with N-methylimidazolium. Some physico-chemical properties, such as density, s
Deep drawing is one of the most important processes for forming sheet metal parts.It is widely used for mass production of cup shapes in automobile,aerospace an
Al-Cu alloy was deformed through equal channel angular pressing (ECAP) by routes A, Ba, Bc and C up to 5 passes. ECAP was done using a 90° die for three differ
Extraction of copper and ammonia from Cu2+-NH3-Cl--H2O solution using laboratorialy synthesized sterically hindered β-diketone (4,4-dimethyl-1-(4-dodecylphenyl
Mg-6%Al-5%Pb and Mg-6%Al-5%Pb-0.55%Zn-0.22%Mn (mass fraction) alloys were prepared by induction melting with the protection of argon. The corrosion behaviors of