论文部分内容阅读
This paper introduces a low-cost infrared absorbing structure for an uncooled infrared detector in a standard 0.5 m CMOS technology and post-CMOS process. The infrared absorbing structure can be created by etching the surface sacrificial layer after the CMOS fabrication, without any additional lithography and deposition procedures. An uncooled infrared microbolometer is fabricated with the proposed infrared absorbing structure.The microbolometer has a size of 6565 m2and a fill factor of 37.8%. The thermal conductance of the microbolometer is calculated as 1.3310 5W/K from the measured response to different heating currents. The fabricated microbolometer is irradiated by an infrared laser, which is modulated by a mechanical chopper in a frequency range of 10–800 Hz. Measurements show that the thermal time constant is 0.995 ms and the thermal mass is 1.3210 8J/K. The responsivity of the microbolometer is about 3.03104V/W at 10 Hz and the calculated detectivity is 1.4108cm Hz1=2/W.
This paper introduces a low-cost infrared absorbing structure for an uncooled infrared detector in a standard 0.5 m CMOS technology and post-CMOS process. The infrared absorbing structure can be created by etching the surface sacrificial layer after the CMOS fabrication, without any additional lithography and deposition procedures. The uncooled infrared microbolometer is fabricated with the proposed infrared absorbing structure. The microbolometer has a size of 6565 m2 and a fill factor of 37.8%. The thermal conductance of the microbolometer is calculated as 1.3310 5W / K from the measured response to different thermal currents. The fabricated microbolometer is irradiated by an infrared laser, which is modulated by a mechanical chopper in a frequency range of 10-800 Hz. Measurements show that the thermal time constant is 0.995 ms and the thermal mass is 1.3210 8J / K The responsivity of the microbolometer is about 3.03104 V / W at 10 Hz and the calculated detectivity is 1.4108 cm Hz1 = 2 / W.