4种阔叶树种叶中氮和磷的季节动态及其转移(英文)

来源 :生态学报 | 被引量 : 0次 | 上传用户:qq165247254
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
从叶完全展开到生长季结束 ,对常绿阔叶树种日本米槠 (Castanopsis cuspidata(Thunb.) Schottky)和具柄冬青 (Ilexpedunculosa Miq)及落叶阔叶树种栎 (Quercus serrata Murr.)和栓皮栎 (Quercus variabilis Blume)叶片的 N和 P浓度、含量和养分转移进行了测定 .在生长期中日本米槠新叶的 N浓度在 5月为 36 .6 g/ kg,然后降到 15 .5和 17.5 g/ kg之间 ,其老叶的N浓度波动于 10 .4和 13.1g/ kg的范围内 ,而具柄冬青新叶的 N浓度从 2 7.3下降到 16 .0 g/ kg,接着上升到 18.3g/ kg,其老叶的 N浓度在 12 .0到 15 .5 g/ kg的范围内。栎和栓皮栎的叶 N浓度分别从 2 8.8下降到 18.1g/ kg和从 2 8.5下降到17.5 g/ kg。日本米槠新叶的 N含量从 1.5 4下降到 1.35 g/ m2 ,接着上升到 1.5 0 g/ m2 ,其老叶 N含量从 1.36下降到1.0 0 g/ m2 ,接着上升到 1.2 1g/ m2 ,而具柄冬青新叶的 N含量从 2 .2 5下降到 1.6 0 g/ m2 ,接着上升到 2 .2 0 g/ m2 ,其老叶的 N含量从 2 .13下降到 1.6 5 g/ m2。栎和栓皮栎的叶 N含量分别从 2 .10下降到 1.2 8g/ m2和从 2 .95下降到 2 .13g/ m2。日本米槠新叶的 P浓度由 3.39g/ kg降到 1.12和 1.15 g/ kg之间 ,其老叶的 P浓度变化于 0 .6 6和 0 .88g/ kg的范围内 ,而具柄冬青新叶的 From the complete development of leaves to the end of the growing season, the effects of Castanopsis cuspidata (Thunb.) Schottky and Ilex pedunculosa Miq and deciduous broad-leaved Quercus serrata Murr. And Quercus serrata Quercus variabilis Blume) leaf N and P concentration, content and nutrient transfer were measured in the growing season in the new Japanese rice cane N concentration in May was 36.6 g / kg, and then dropped to 15.5 and 17.5 g / kg, the concentration of N in old leaves fluctuated between 10.4 and 13.1 g / kg, while the N concentration of new stems of A. hollyi decreased from 7.3 to 16.0 g / kg and then increased to 18.3 g / kg, and the old leaf’s N concentration is in the range of 12.0 to 15.5 g / kg. Leaf N concentrations in Quercus variabilis and Quercus variabilis decreased from 28.8 to 18.1 g / kg and from 8.5 to 17.5 g / kg, respectively. The N content of new leaves of Japanese rice cake decreased from 1.54 to 1.35 g / m2, then increased to 1.5 0 g / m2. The content of N in old leaves decreased from 1.36 to 1.0 0 g / m2, then increased to 1.2 1 g / m2, However, the N content of new stems decreased from 2.55 to 1.6 0 g / m2 and then increased to 2.02 g / m2, while the N content of old leaves decreased from 2.13 to 1.6 5 g / m2 . Leaf N content of Quercus variabilis and Quercus variabilis decreased from 2.10 to 1.2 8g / m2 and from 2.95 to 2.13g / m2, respectively. The P concentration of new leaves of Japanese poplar reduced from 3.39g / kg to 1.12g / kg and 1.15g / kg, the P concentration of old leaves varied from 0.66 and 0.88g / kg, New leaf
其他文献
在机床设计中,有时由于结构上的限制的需要,主轴部件采用三支承结构。从力学观点来看主轴部件静刚度,三支承主轴部件有什么特点?有关参数如何选择才能使主轴部件静刚度为最大
锅炉是火力发电机组中的三大主机之一。锅炉中的许多主要部件,如过热器、再热器和蒸汽导管等均用耐热钢制造。保证耐热钢性能是使锅炉安全运行的重要条件。随着过热蒸汽温度
本文根据冷压塑性变形后热处理试验,建立了50Mn18Cr4护环用钢的静态再结晶全图.实验测定,目前我国使用的该牌号钢,经过不同程度的冷压变形后在950℃左右进行加热处理,可以获
1997年是中华民族历史上极不平凡的一年。党的十五大召开、香港回归祖国这两件大事,将对中华民族的振兴产生重大和深远的影响,也必将给湖北经济发展提供大好机遇。做好今年
采用制药厂的工业废料4—甲基吡啶釜残、工业氯化苄、匀染剂102及酒精为原料,制成缓蚀剂——“7701”.试验结果表明,它的缓蚀性能较好.文中初步探讨了这种缓蚀剂的作用机理,
人力资本具有的创新能力对事务所的贡献是一般人力资源、非人力资本所无法比拟的:首先,合理利用人力资本创新是提高审计质量的关键之一;其次,合理利用人力资本创新是审计风险
轮式起重机的钢结构普遍应用焊接结构。研究焊接产生的残余应力对结构强度的影响,已成为一个重要的课题,特别对于重量轻而强度要求较高的结构(如起重臂等)更为突出。在焊接
高温形变热处理使一种铁镍基合金的室温和高温屈服强度、抗张强度、塑性和室温冲击韧性大幅度提高,且经1100℃形变热处理的合金于650℃的持久性能亦不低于正常热处理的合金。
钛合金蒙皮与飞机理论外形有关,要求有较高的成形精度和形状稳定性,为此我们采用了自阻加热拉型成形法。即利用钛合金有较高的电阻率,将钛板通电,使其产生高热,钛板在一定温
中国科学院出版图书情报委员会期刊计算机应用领导小组组织了30多个期刊编辑部的50名代表,于5月25日至29日在合肥举行了会议,着重交流了使用 CCT 软件进行微机排版的经验,探