论文部分内容阅读
柞蚕生产是我区一项新兴产业,它投入少、效益高、周期短、见效快、技术简单等特点,已被林区职工所接受。我区有33万公顷柞林,20%用于放蚕,可解决1.2万人就业。
浅谈大兴安岭地区的柞蚕生产
【摘 要】
：
柞蚕生产是我区一项新兴产业,它投入少、效益高、周期短、见效快、技术简单等特点,已被林区职工所接受。我区有33万公顷柞林,20%用于放蚕,可解决1.2万人就业。
【机 构】
：
黑龙江省大兴安岭营林局技术推广站,黑龙江省大兴安岭农林科学院
【出 处】
：
中国新技术新产品
【发表日期】
：
2004年期
其他文献
Direct Electroless Nickel Plating on AZ91D Magnesium Alloy from a Sulfate Solution and its Depositio
A bath of electroless plating Ni on the AZ91D magnesium alloy, containing sulfate nickel, was given in this paper. The nucleation mechanism of Ni-P deposits on
This paper gives a short introduction to the typical process route and material properties of these steels in comparison to standard martensitic corrosion-resis
A reasonable pre-treatment and an ultrasonic pre-plating Cu film were applied for sintering NdFeB permanent magnet. The samples were then plated in neutral bath
Influnce of Stoichiometry and Molar Ratio of Barium Ferrite Thin Film Synthesized by Sol-gel on Alum
Amorphous gels were processed with a varying Fe/Ba ratio of 11/5, 28/2, 10.5/1 in water and Solvent. Iron and barium nitrites with specific molar ratio was solv
Effect of Cd and Sn Addition on the Microstructure and Mechanical Properties of Al-Si-Cu-Mg Cast All
The present work has investigated the effect of trace elements Cd and Sn on the microstructure and mechanical properties of Al-Si-Cu-Mg cast alloy. With the inc
In the present reserch, a model has been proposed for estimate fracture toughness of Nickel-phosphorus (EN) layers. For this purpose, high phosphorus (9%) EN co
Nowadays, in the auto industry, the need for improvement of fuel efficiency is getting increased more and more in terms of the global warming, as well as the ne
Effect of Zr Addition on Resistance to High Temperature Softening and Resistivity of 6082 Al-Mg-Si A
The influence of zirconium on the resistance to high temperature softening of 6082 Al-Mg-Si alloys has been researched. The softening process of 6082 alloys wit
基于二维带输运模型,研究了LiNbO3:Fe晶体中光束从自散焦向自聚焦动态转换过程.结果表明暗辐照在动态转换过程中起着非常重要的作用,当暗辐照较小时动态转换过程才发生.在暗
Thermodynamic prediction of the increment of the formation temperature of proeutectoid ferrite by appliedstress is nearly consistent with the wxperfimental data