机油散热在齿轮室后边右上角,钻一个八至十毫米的孔,在孔的上下五至八毫米处各钻一个三至四毫米的小孔。剪一块铁片,直径大于这三个孔连成的直线,制成凹形,中间填上海绵或稀纱布,两边留小缝,两个小孔处用铆钉铆住。这样改的作用是:(一)降低曲轴箱压力,清洁空气,减少磨损,延长机器寿命;(二)既能散热,又不喷油雾,减少机油消耗。由原来一昼夜耗四市斤降到一市斤半。二级过滤用直径三十七毫米,长一百二十至一百三十毫米的一段旧喷雾器管,一端用薄铁皮焊好,不能漏油,做成柴油过滤器外壳,里边放入1105八马力柴油机滤清器滤芯。过 Heat the oil in the upper right-hand corner of the rear of the gear room, drill a hole of eight to ten millimeters, and drill a hole of three to four millimeters at the top and bottom of the hole at five to eight millimeters. Cut a piece of iron, diameter greater than the three holes into a straight line, made of concave, filled with sponge or gauze in the middle, leaving small seams on both sides, two holes riveted with rivets. The role of this change is: (a) reduce the pressure on the crankcase, clean the air, reduce wear and prolong the life of the machine; (b) both heat, no fuel spray, reduce oil consumption. From the original day and night consumption of four pounds reduced to one kilogram of catty. Secondary filter with a diameter of thirty-seven millimeters, one hundred twenty to one hundred and thirty millimeters of a section of the old sprayer tube, one end of the thin iron with a good welding, can not leak oil, made of diesel filter housing, inside into the 1105 eight Horsepower diesel engine filter element. Too