【摘 要】
：
The depth and nature of the subsurface damage in a silicon wafer will limit the performance of IC components.Damage microstructures of the silicon wafers ground
【机 构】
：
Key Laboratory for Precision and Non-traditional Machining Technology of Chinese Ministry of Educati
【基金项目】
：
国家自然科学基金;the National Natural Science Foundation of China in Major Project Program
论文部分内容阅读
The depth and nature of the subsurface damage in a silicon wafer will limit the performance of IC components.Damage microstructures of the silicon wafers ground by the #325,#600, and #2000 grinding wheels was analyzed.The results show that many microcracks,fractures, and dislocation rosettes appear in the surface and subsurface of the wafer ground by the #325 grinding wheel.No obvious microstructure change exists.The amorphous layer with a thickness of about 100 nm,microcracks, high density dislocations,and polycrystalline silicon are observed in the subsurface of the wafer ground by the #600 grinding wheel.For the wafer ground by the #2000 grinding wheel,an amorphous layer of about 30 nm thickness,a polycrystalline silicon layer,a few dislocations,and an elastic deformation layer exist.In general,with the decrease in grit size,the material removal mode changes from micro-fracture mode to ductile mode gradually.
其他文献
Single hit compression tests were performed at 1 223-1 473 K and strain rate of 0.1-10 s-1 to study hot deformation behavior and flow stress model of F40MnV ste
In order to investigate the regularity of metal magnetic signals of ferromagnetic materials under the effect of applied load, the static tensile test of Q235 st
A new method to evaluate the fitness of the Bayesian networks according to the observed data is provided. The main advantage of this criterion is that it is sui
A microseismic monitoring system was used in the Donggua Shan underground copper mine,and its application was introduced.The spacial distribution of the seismic
Combining the GIS (geographic information systems) grid-based data with four proposed column-based 3D slope stability analysis models,a comprehensive solution o
An efficient design-for-testability (DFT) technique is proposed to achieve low overhead for scan-based delay fault testing. Existing techniques for delay test s
The deformation mechanism of the spray formed 70Si30Al alloy was studied by hot compression on a Gleeble-1500 test machine.It is shown that hot deformation of t
A PANI/TiO2 composite film deposited on the glass surface was successfully prepared using sol-gel dip-coating technique and chemical oxidation method.The film w
The effects of pouring temperature and short electromagnetic stirring with low strength on the microstructures of AlSi7Mg alloy were investigated.The results sh
In view of certain defects of common rough communication, using the S-rough sets, this article presents a S-rough communication model. The S-rough communication