【摘 要】
：
A surface plasmon resonance (SPR) sensing system based on the optical cavity enhanced detection technique is experimentally demonstrated. A fiber-optic laser cavity is built with a SPR sensor inside. By measuring the laser output power when the cavity is
【机 构】
：
SchoolofElectronicandInformationEngineering,BeihangUniversity,Beijing100191NationalCenterforNanoscie
【出 处】
：
ChineseOpticsLetters
论文部分内容阅读
A surface plasmon resonance (SPR) sensing system based on the optical cavity enhanced detection technique is experimentally demonstrated. A fiber-optic laser cavity is built with a SPR sensor inside. By measuring the laser output power when the cavity is biased near the threshold point, the sensitivity, defined as the dependence of the output optical intensity on the sample variations, can be increased by about one order of magnitude compared to that of the SPR sensor alone under the intensity interrogation scheme. This could facilitate ultra-high sensitivity SPR biosensing applications. Further system miniaturization is possible by using integrated optical components and waveguide SPR sensors.
其他文献
论述了复合激光等离子体中类锂离子软X射线放大的理论和实验，报导了采用碰撞辐射模型作为流体动力学编码的一种后处理程序所计算的时间和空间相关的粒子数及反转密度。讨论了在等离子体实验中诊断放大的精度。给出了增益的时间积分和时间分辨测量，特别是铝的类锂10.57 nm测量结果。测量表明，在由3 ns激光脉冲产生的等离子体中，放大辐射峰值约发生在脉沖极大之后7 ns。以前测出的最大增益-长度乘积是2~2.5。给出了为产生更大增益而设计的未来实验的简短描述。
本文利用二次谐波产生、紫外-可见吸收光谱、A曲线等方法,探讨了四种分子结构相近的半花菁染料衍生物LB膜的非线性光学性能.研究了它们的分子结构与β值大小的关系,分析了引起β值变化的主要原因,证实了极性基团的强弱顺序,并讨论了LB膜中聚集效应程度不同的原因。通过光学二次谐波信号强度与膜层数的关系,对比了样品的成膜性能。
In this paper, a new type of multi-wavelength fiber laser is proposed and demonstrated experimentally. Superimposed fiber grating (SIFG) and chirp fiber Bragg grating (CFBG) are used for wavelength selection. Based on gain equalization technology, by fine
Higher-band self-trapping and oscillation (rotation) of nonlinear quadruple beams in two-dimensional (2D) square photonic lattices are numerically demonstrated. Under appropriate conditions of nonlinearity, a quadruple-like beam can self-trap into localiz
Focus on the tracking target for detection indoor, the angle peak characteristics are analyzed based on uniform circular motion and the void-zone is proposed. The sine angular trajectory is used to transform the actual target into the infield, which impro
最远点采样(FPS)算法可用于三维(3D)目标检测算法中关键点的采集,针对FPS采集的关键点中前景比例较低的问题,提出了一种基于语义分割特征的区域卷积神经网络(Seg-RCNN)3D目标检测算法。用一种基于语义分割特征的最远点采样(SegFPS)算法预测点的语义分割类别,以提高采集关键点中前景点的比例,从而提升Seg-RCNN算法的检测精度。该算法以激光点云作为输入,在第一阶段,利用3D稀疏卷积网
针对室内场景点云平面分割存在的问题,提出一种基于投影长度点云分层和基于均值漂移法向量约束的平面分割新方法。该方法首先通过主成分分析方法估算点云的法向量,再求取点云的投影长度并进行分层,然后取最大分层点云进行法向量约束,利用余下点云拟合求取平面参数并去除该平面模型包含的点云,重复上述步骤以求取所有平面的参数,接着在原始点云中提取模型点云并进行模型优化,得到最终的平面分割结果。实验结果证明,所提方法可
在用光纤放大器补偿损耗的光纤传输线中,用负色散光纤与正色散光纤或色散补偿器件交叉配置,并使传输线中光纤的有效色散适当大于(与平均孤子对应的)理论值,同时在传输线中周期地使用相位共轭器,可以在把放大器间隔提高到与常规光纤通信相同的条件下有效地削弱孤子之间的互作用。本文对实现速率为25 Gbit/s、占空比为1/2、光放大器间隔为100 km、传输距离大于6000 km的光孤子传输作出了数值论证。