【摘 要】
：
In this paper a novel design method of aerodynamic configuration is proposed to inte-grate forebody,strut and inlet for strutjet engine,and a model at design point of Mach number 6 is generated to investigate the aerodynamic performance by both simulation
【机 构】
：
College of Aerospace Engineering,Nanjing University of Aeronautics and Astronautics,Nanjing 210016,C
论文部分内容阅读
In this paper a novel design method of aerodynamic configuration is proposed to inte-grate forebody,strut and inlet for strutjet engine,and a model at design point of Mach number 6 is generated to investigate the aerodynamic performance by both simulations and experiments.The basic flow field employed by proposed method is a combined flow named IBB,which is com-bined by Internal Conical Flow A (ICFA),truncated Busemann flow I (BI) for external section,and truncated Busemann flow II (BII) for internal section.The model configuration is generated by streamline tracing method from basic flow field,in which the forebody section is traced from ICFA and BI flows,and the inlet as well as strut section is traced from BII flow.The simulations in Mach number 4,5,and 6 demonstrate uniform starting flow fields with relatively high total pressure recovery,which agree well with experiments in wind tunnel.Additionally,in low Mach number cases,this inlet could start at Mach number 3 while it is unstarted at Mach number 2.7;in high Mach number cases,a uniform flow could still exist in Mach number 6.5 while a relatively strong shock wave boundary layer interaction is found in cowl area of Mach number 7 case,indicating the inlet designed by proposed method works in a relatively wide Mach number range.
其他文献
In this paper,the fixed-time stability of spacecraft formation reconfiguration (position tracking) is studied.Firstly,a novel nonsingular terminal sliding mode surface is designed and based on which a fixed-time coordinated controller is designed to keep
In this paper,the flow field characteristics of Oblique Detonation Waves (ODWs)induced by a finite wedge under argon dilution are studied by solving the Euler equations with a detailed chemical model of hydrogen and air.First,the effects of the expansion
A Reynolds-Averaged Navier Stokes (RANS)-information analytical method for pre-dicting Rotor-Stator Interaction (RSI) broadband noise is established in this paper.First,the tur-bulence information is deduced from RANS simulation result.Then,the unsteady l
In the classical form,the Poisson Multi-Bernoulli Mixture (PMBM) filter uses a PMBM density to describe target birth,surviving,and death,which does not model the appearance of spawned targets.Although such a model can handle target birth,surviving,and dea
As the load and working environment temperature increasing,high efficiency oil lubrica-tion was urgently needed for the main bearing of aeroengine.However,the low oil capture efficiency of radial oil scoop affects the application of under-race lubrication
To diagnose the Open-Circuit (OC) fault in the novel fault-tolerant electric drive system,based on d-q-axis current signal,a strong robustness diagnosis strategy is proposed and investi-gated.Fewer independent power supplies and converters are required in
A loss of ground directional stability can trigger a high-speed Unmanned Aerial Vehicle(UAV) to veer off the runway.In order to investigate the combined effects of the key structural and oper-ational parameters on the UAV ground directional stability from
In modern gas turbines,the High Pressure Turbine (HPT) is exposed to an extreme ther-mal environment due to the burned gases leaving the combustor.The burned gases are character-ized by flow and temperature distortions that effect the aerodynamics and hea
Three Plasma Synthetic Jet Actuators (PSJA) under the high-frequency actuation are used to control the Shock Wave Boundary Layer Interaction (SWBLI),a high-speed schlieren image processing method based on spatial Fourier transform as well as snapshot prop
This paper considers effects of Rotating Inlet Distortion (RID) on a two-stage axial com-pressor and the stabilization effects of a casing treatment subjected to the considered RID.In multi-spool engines,the downstream compressor suffers a RID when the up