【摘 要】
:
In order to ameliorate the electrochemical hydrogen storage performances of La-Mg Ni system A2B7-type electrode alloys,the partial substitution ofM (M =Zr,Pr) f
【机 构】
:
Key Laboratory of Integrated Exploitation of Baiyun Obo Mutti-Metal Resources,Department of Function
论文部分内容阅读
In order to ameliorate the electrochemical hydrogen storage performances of La-Mg Ni system A2B7-type electrode alloys,the partial substitution ofM (M =Zr,Pr) for La was performed.The melt spinning technology was used to fabricate the La0.75-xMxMg0.25Ni3.2Co0.2Al0.1 (M =Zr,Pr; x =0,0.1) electrode alloys.The influences of the melt spinning and substituting La with M (M =Zr,Pr) on the structures and the electrochemical hydrogen storage characteristics of the alloys were investigated.The analysis of XRD,SEM,and TEM reveals that the as-cast and spun alloys have a multiphase structure composed of two main phases (La,Mg)2Ni7 and LaNi5 as well as a residual phase LaNi2.The as-spun (M =Pr) alloy displays an entire nanocrystalline structure,while an amorphous-like structure is detected in the as-spun (M =Zr) alloy,implying that the substitution of Zr for La facilitates the amorphous formation.The electrochemical measurements exhibit that the substitution of Pr for La clearly increases the discharge capacity of the alloys; however,the Zr substitution brings on an adverse impact.Meanwhile,the M (M =Zr,Pr) substitution significantly enhances its cycle stability.The melt spinning exerts an evident effect on the electrochemical performances of the alloys,whose discharge capacity and high rate discharge ability (HRD) first mount up and then fall with the growing spinning rate,whereas their cycle stabilities monotonously augment as the spinning rate increases.
其他文献
Carbon nanotubes (CNTs) were coated by tungsten using metal organic chemical vapor deposition.Magnetic stirring was employed to disperse the W-coated CNTs (W-CN
To deal with fault detection and diagnosis with incomplete model for dead reckoning system of mobile robot,an integrative framework of particle filter detection
An approach was proposed to specify the C4ISR capability of domain-specific modeling language.To confine the domain modeling within a standard architecture fram
A low power 640×480 OLED-on-silicon chip design that used in microdisplay was presented.A novel pixel circuit was proposed to meet the special requirement of O
The surface profile of laser peening with square spots was compared with that of circle spots,and the microstructure of laser peened titanium alloy Ti-6Al-4V in
The flow pattern behaviour of falling liquid film over three horizontal cylinders was evaluated.These flows can take three forms:discrete droplets,individual je
A new method of prefetching data blocks from the NVCache to the page cache in main memory and cascading prefetching n-blocks from a hard disk to the NVCache tog
The fracture of a drilling tail made of 18CrNi3MoA steel in the exchanging water hole was analyzed in terms of inclusions,prior anstenite grain size,carburized
Ti-62A alloy plates with three different types of microstructure,fully equiaxed,bimodal,and Widmanst(a)tten,were obtained by various heat treatments to investig
Three new rare earth ternary complexes,RE(PB)3bpy (RE-Sm3+,Eu3+,and Tb3+),were synthesized by the reaction of 1-(p-phenylethynyl-phenyl)-1,3-butanedione (HPB) a