Microstructure and Composition of Hydration Products of Ordinary Portland Cement with Ground Steel-m

来源 :武汉理工大学学报英 | 被引量 : 0次 | 上传用户:fatcat120
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
The effect of ground steel-making slag on microstructure and composition of hydration products of ordinary Portland cement (OPC) was investigated by mercury intrusion porosimetry ( MIP ), X- ray diffraction (XRD) and differential thermal analysis (DTA). Results show that ground steel-making slag is a kind of high activity mineral additives and it can raise the longer-age strength of OPC mortar. The total porosity and average pore diameter of OPC paste with groand steel-making slag increase with the increase of the amount of ground steelmaking slag replacing OPC at various ages, while after 28 days most pores in OPC paste with ground steel-making slag do not influeace the strength because the diameter of those pores is in the rang of 20 to 50nm. The hydration mechanism of ground steel-making slag is similar to that of OPC but different from that of fly ash and blast furnace slag. The hydration products of ground steel-making slag contain quite a lot of Ca( OH)2 in long age.
其他文献
The influence of Mo on the microstructure, bending strength and HV of Ti/Al2O3 composite was studied, and the influence mechanism was analyzed . The results ind
This paper presents a new kind of image retrieval system which obtains the feature vectors of images by estimating their fractal dimension; and at the same time
The novel rapidly solidified TiC/FeAl composite coatings were fabricated by laser cladding on the substrate of 1Cr18Ni9Ti stainless steel, particular emphasis h
Fracture energy in strain softening regime was investigated analytically by considering microstructures interaction and interplay. Based on gradient-dependent p
The thermogravimetric analysis of binary Cu 80Ni alloys prepared respectively by conventional casting(CA) and mechanical alloying(MA) techniques and presenting
本文应用Bass创新扩散模型,对不同地区互联网扩散的差异进行研究。首先,利用中国互联网络中心公布的有关数据估计不同地区互联网扩散模型的参数;其次,根据参数估计结果,用聚
7075 aluminum alloy thick-plates were produced by three processing routines: commercial hot-rolling followed by heat treatment of quenching and ageing (HR+QA),
The phase-separation glasses with composition of Na2 O(9. 0) B2 O3 (25.0)- SiO2 (66.0) ( in mole ratio ) were leached with hydrochloric acid, and porous glasses
In order to study the subboundaries evolution in superplastically deformed NiAl, the positron lifetime change during superplastic deformation process was measur
The friction and wear properties of the nylon coating, prepared by hot-extrusion, used to protect the surface of the flexible continuous sucker rod were studied