插皮接 插皮接只适用于较粗大的砧木,生产上常用于根部嫁接、近地面嫁接和大树高接。时间从春李树液流动到9月砧木离皮期间都可进行嫁接。但以枣树发芽前后嫁接成活率最高,当年生长量也大。 将接穗下端削成长3厘米左右的大斜面,再在背面削个小斜面,并把斜面最下端削尖,注意顶芽最好在小斜面一方。在砧木距地面4—6厘米处剪断,削平剪口,在砧木馆风面用刀尖将剪口 Plug skin patch only for thicker rootstocks, the production is often used for root grafting, near-surface grafting and tall trees. Time from the flow of spring plum liquid to September rootstocks can be grafted during the graft. However, the highest survival rate of jujube trees before and after grafting, when the amount of growth is also large. The lower end of the scion cut into a large bevel about 3 cm long, and then cut a small bevel on the back, and the bevel the lowest end of the sharpened, note that the top of the bud is best in a small bevel. In the rootstock 4-6 cm from the ground at the cut, flat cut, cut in the wind with the tip of the anvil Museum will notches