Thermal Management Controller for Heat Source Temperature Control and Thermal Management

来源 :上海交通大学学报(英文版) | 被引量 : 0次 | 上传用户:houchen02
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
In many heat recovery processes, temperature control of heat source is often required to ensure safety and high efficiency of the heat source equipment. In addition, the management of recovered heat is important for the proper use of waste heat. To this aim, the concept of thermal management controller (TMC), which can vary heat transfer rate via the volume variation of non-condensable gas, was presented. Theoretical model and experimental prototype were established. Investigation shows that the prototype is effective in temperature control. With water as the working fluid, the vapor temperature variation is only 1.3 ℃ when the heating power varies from 2.5 to 10.0 kW. In variable working conditions, this TMC can automatically adjust thermal allocation to the heat consumer.
其他文献
A new group key management scheme against the unreliable wireless communication channel and unsafe environment was proposed for wireless sensor network (WSN). In the proposed scheme, broadcast polynomial, generated over finite field Fq based on the secret
Extraction of moving objects is an important and fundamental research topic for many video ap-plications. This paper addresses an unsupervised spatio-temporal segmentation scheme to extract moving objects from video sequences. The temporal segmentation lo
Hybrid wavelength-division-multiplexing (WDM)/time-division-multiplexing (TDM) ethernet passive optical networks (EPONs) can achieve low per-subscriber cost and scalability to increase the number of subscribers. This paper discusses dynamic wavelength and
In this paper, a modified genetic local search algorithm (MGLSA) is proposed. The proposed algorithm is resulted from employing the simulated annealing technique to regulate the variance of the Gaussian mutation of the genetic local search algorithm (GLSA
Experiment measurement is adapted to study the secondary flow of turbine. The subsonic stator experiment flow tunnel is set up. Two different inlet velocities and three different stator heights are applied. The method of a rotating slanted hotwire is intr