论文部分内容阅读
Depositional and Diagenetic Controls on Sandstone Reservoirs with Low Porosity and Low Permeability
【机 构】
：
Shandong Provincial Key Laboratory of Depositional Mineralization & Sedimentary Minerals,Institute o
【出 处】
：
地质学报（英文版）
【发表日期】
：
2004年期
其他文献
In this paper,it presents the results of calculation of solidification process of copper continuous cast bar by cross section size 120 mm × 70 mm with applicat
In this paper,the results of exploration macrostructure and microstructure of continuous cast copper bars are shown. Quantitative parameters of copper cast bars
Single point diamond fly cutting is widely used in the manufacture of large-aperture ultra-precision optical elements. However,some micro waviness( amplitude ab
Micro milling has many advantages in fabricating three-dimensional(3D) structure in micrometer scale. The micro milling machine tool with high positioning accur
The synthesis of a low cost no-bake furan resin with a high strength was researched in this paper. Through the analysis of main factors influencing the strength
A new low-cost method of reclaiming mixed foundry waste sand based on wet-thermal composite reclamat
A lot of mixed clay-resin waste sand from large-scale iron foundries is discharged every day; so mixed waste sand reclamation in low cost and high quality has a
The effect of Si addition and heat treatment on the Al-5wt.%Fe alloy has been investigated by OM, SEM-EDS and XRD. The results show that the Si plays a signific
Crusher hammers for the mineral processing industry must meet the demands of both high wear resistance at the hammer head and high impact toughness at the hamme
The influence of Sr addition on pore formation in directionally solidified Al-12.3wt.% alloy was investigated using X-ray detection, optical microscope, and SEM
Sn60Pb40 alloy powders were fabricated using the planar flow casting(PFC) atomization process. By using OM, SEM and EPMA, the characteristics of the morphologie