论文部分内容阅读
为研究热解炭织态结构的生成规律,采用不同压强的甲烷为碳源,在1 100℃条件下进行了化学气相沉积和化学气相渗透实验。化学气相沉积以具有不同表面积/自由体积比([A/V]值)的直通方形多孔陶瓷为基体;化学气相渗透实验在直径为1mm细直孔内表面沉积和对炭纤维体积分数为7%的炭毡进行致密化。借助正交偏光显微镜(消光角)和透射电子显微镜(定向角)对在不同实验条件下制备的热解炭进行分析和定量表征。研究发现:热解炭的织态结构可以在两种不同的沉积条件下形成。当甲烷压强较低时为化学生长阶段;当甲烷压强较高时为物理形核阶段。在化学生长控制阶段,热解炭的织态结构可以利用之前提出的“颗粒填充模型(P-F模型)”加以解释。该模型假设高织构热解炭的沉积一定对应于气相中存在具有合适比例的芳香化合物(例如苯)和线性小分子(主要是C2H2),当二者的浓度比偏离该最优比(或者偏大,或者偏小),均将导致中织构甚至低织构热解炭的生成。在化学生成控制阶段,化学气相沉积和化学气相渗透对热解炭织态结构影响的差别,除了[A/V]值而外,还有氢气的作用。在化学气相渗透过程中,基体内部生成的氢气快速扩散至基体表面,使内外沉积速率和织态结构均发生较大变化。
In order to study the formation regularity of pyrolytic carbon texture structure, different pressure methane was used as carbon source, and chemical vapor deposition and chemical vapor infiltration experiments were carried out at 1 100 ℃. The chemical vapor deposition was carried out on straight-through square porous ceramics with different surface area / free volume ratio ([A / V]). The chemical vapor infiltration experiments were carried out on the inner surface of fine holes with a diameter of 1 mm and the carbon fiber volume fraction of 7% Of carbon felt densification. The pyrolytic carbon prepared under different experimental conditions was analyzed and quantitatively characterized by means of orthogonal polarization microscope (extinction angle) and transmission electron microscopy (orientation angle). It is found that the texture structure of pyrolytic carbon can be formed under two different depositional conditions. When the methane pressure is low for the chemical growth stage; when the methane pressure is higher for the physical nucleation stage. At the chemical growth control stage, the texture structure of pyrolytic carbon can be explained by the “particle-filling model (P-F model)” previously proposed. The model assumes that the deposition of highly textured pyrolytic carbon must correspond to the presence of a suitable proportion of aromatic compounds (eg benzene) and linear small molecules (mainly C2H2) in the gas phase when the concentration ratio deviates from the optimal ratio (or Too large, or too small) will result in the formation of mesostructures and even low-texture pyrolytic carbons. In chemical control stage, chemical vapor deposition and chemical vapor infiltration on pyrolysis carbon texture structure of the difference, in addition to [A / V] value, there is the role of hydrogen. During chemical vapor infiltration, the hydrogen generated inside the matrix rapidly diffuses to the surface of the substrate, causing great changes in both the deposition rate and the texture of the substrate.