Effects of truncated Gaussian beam on the performance of fiber optical synthetic aperture system

来源 :OptoelectronicsLetters | 被引量 : 0次 | 上传用户:skyboat521
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
In the fiber optical synthetic aperture (FOSA) system, the diffraction of the Gaussian beam limited by the aperture in exit pupil plane of fiber collimator is studied theoretically, and the axial and transverse irradiance distributions are obtained. The point spread function (PSF) and modulation transfer function (MTF) of the truncated Gaussian beam array are computed numerically with different truncation factors. The results show that the diffraction of the truncated Gaussian beam array agrees with the uniform-beam Rayleigh diffraction when the truncation factor is less than 0.5, but little power is transmitted. The PSF and MTF are degraded, but more power can be contained when the truncation factor is larger. The selection of the truncation factor is a trade-off between the loss of transmission and the qualities of PSF and MTF in practical application.
其他文献
介绍了一种用布拉格光纤光栅制作啁啾光纤光栅的方法。采用氢氟酸腐蚀布拉格光纤光栅,使光栅的横截面沿光栅轴向逐渐变小,然后对光栅施加1.50N的拉力,在光栅轴向建立应变梯度,制作出长15mm、峰值反射率达92%、反射半高宽为5nm的啁啾光纤光栅。
根据红外上转换材料测试实验系统的使用要求,选择Ta2O5和SiO2作为高低折射率膜料,通过椭偏仪测试膜料色散代入膜系软件进行设计优化,采用电子枪蒸镀的物理沉积技术,同时利用霍尔离子源辅助沉积提高膜料折射率,并通过调整工艺参数和改进光学监控方法解决了误差在监控波长处的累积问题,成功在石英基底上制备了干涉截止滤光片。镀膜后的石英基片在808、980、1064 nm 波长处透射率小于0.01%,可见光波段的平均透射率大于90%。结果表明该干涉截止滤光片的镀制满足上转换实验系统的使用要求。
本文报道使用蒸汽泡和两光子两步激发方法,测量原子激发态敏化荧光I3/21和直接荧光I(3/2)~2其与温度的关系,得到与基态(5~2S(1/2)铷原子碰撞产生的铷7~2D(5/2)→7~2D(3/2)和7~2D(3/2)→7~2D(5/2)精细结构转移截面分别为:σ(fs)=4.7×10~(-13)cm~2、σ(fs)~’=7.0×10~(-13)cm~2;碰撞转移出7~2D双态的转移截面σ(tr)(5/2)=0.62×10~(-13)cm~2.由计算的7~2D态几何截面σ(geom)能够相对很好地描述σ
期刊
期刊
A model of sub-wavelength metallic grating without host media is proposed. Under the excitation of TE polarized light, the extraordinary transmission is also found, and their transmission energy distributions corresponding to different structural paramete
期刊
使用I类非共线相位匹配结构,建立三维空间和时间的数值计算模型,优化设计了一个焦耳级光参量啁啾脉冲放大(OPCPA)系统。该系统主要由两级三硼酸锂(LBO)预放大器和一级三硼酸钙氧钇(YCOB)功率放大器组成。通过将抽运光的时空波形整形成超高斯形状、使用走离补偿结构、仔细分析及选取各级参量放大器的长度等措施,保证了最后输出信号光的能量稳定性,同时还获得了较高的能量转换效率和好的光束质量。理论设计结果表明,该系统的各项参数均满足神光Ⅱ九路前端的技术指标要求,是一个具有可行性的设计方案。
Fresnel incoherent correlation holography (FINCH) is a self-interference based super-resolution three-dimensional imaging technique. FINCH in inline configuration requires an active phase modulator to record at least three phase-shifted camera shots to re
将一定长度、 均匀周期的光纤光栅沿轴向刚性粘贴于厚度呈阶跃分布的等腰三角状悬臂梁界线附近的表面上, 通过观测该光栅反射谱中两个峰值的间距来监测梁自由端在垂直于表面方向上的位移。 实验表明该无源温漂位移线性传感装置的传感灵敏度达9.24×10-2 nm/mm, 与理论值9.4×10-2 nm/mm非常接近。
期刊