【摘 要】
：
Solid state B-offerings (FeB compound) were used for plasma-assisted boronizing on Ti6Al4V alloy by double glow discharge plasma alloying technique (DGPSA). Dur
【机 构】
：
Research Institute of Surface Engineering,Pingshuo Coal Industrial Company
论文部分内容阅读
Solid state B-offerings (FeB compound) were used for plasma-assisted boronizing on Ti6Al4V alloy by double glow discharge plasma alloying technique (DGPSA). During all experiment processing there was no harmful and toxic. The thickness and morphology, phase formation, elements concentrations and wear properties of boride layers were examined by means of optical microscopy, Vickers microhardness, X-ray diffraction, glow discharge optical emission spectroscopy and Ball-disk wear tests. The results show that friction coefficient of boride alloying samples versus corundum ball is lower than that of Ti6Al4V samples, as well as wear rate. This indicates that plasma-assisted boronizing of Ti6Al4V alloy has a high potential for industrial applications under tribological conditions.
其他文献
Graphite and Al2O3 short fibers reinforced Mg-Al-Zn alloy hybrid composites were fabricated by perform squeeze-infiltration route. The effects of the volume of
The microstructure and mechanical properties of AZ80 alloy were investigated during thermal processing. The samples of 4 mm in thickness machined from cast ingo
Low energy consumption is one of the main challenges for wireless video transmission on battery limited devices. The energy invested at the lower layers of the
Li3V2(PO4)3 cathode material was prepared by a carbon-thermal reduction (CTR) process. V2O5,LiOH-H2O,NH4H2PO4 and C were used as starting materials to synthesiz
This review provided some recent progress of the research on corrosion mechanisms of magnesium and its alloys and a basis for follow-on research. Galvanic corro
SiCp/1060A1, SiCp/ZL101, SiCp/ZL102 composites with SiCp volume fraction of 55% were fabricated by pressureless infiltration. The microstructure was examined an
The structural, morphological, mechanical and tribological characterization of nanoscaled multilayer TiN/TaN coatings deposited by magnetron sputtering technolo
The effect of two-stage aging on the microstructures and superplasticity of 01420 Al-Li alloy was investigated by means of OM, TEM analysis and stretching exper
Electropolishing has been used in NiTi alloy in several fields for its special characteristics,but its essential details and electropolishing mechanism have not
A technique based on viscous polymer processing (VPP) was described,which can produce high ceramic content green fibers. PZT-5 ceramic powders were ball milled