To explore a more convenient method for measuring the focused ultrasound power,a piezoelectric ceramic plate was used to receive ultrasonic signal directly.Due to an acoustic force acts on the surface of piezoelectric ceramic plate,the piezoelectric response was obtained by means of electromechanical analogy,which was composed of voltage response caused by forced vibration and high frequency attenuation response caused by natural vibration.The conversion relationship between output signal of piezoelectric ceramic plate and acoustic power of transducer was analyzed.The envelope of output piezoelectric signal was extracted in twice,and a voltage amplitude curve with sinusoidal distribution that could describe the changes of acoustic power was obtained.Under different drive voltage of transducer,the maximum peak voltage of envelope curve was found respectively.Their squared values were made a linear fitting with acoustic power measured by acoustic power meter,and then the proportional coefficient of theoretical relational expression was calibrated.The experimental results are in good agreement with the theory.The relative error between calibrated theoretical acoustic power and that measured by acoustic power meter was less than 8.7%.The paper can provide a guideline for measuring acoustic power of transducer by using piezoelectric signal. To explore a more convenient method for measuring the focused ultrasound power, a piezoelectric ceramic plate was used to receive an ultrasonic signal directly. Due to an acoustic force acts on the surface of a piezoelectric ceramic plate, the piezoelectric response was obtained by means of electromechanical analogy, which was composed of voltage response caused by forced vibration and high frequency attenuation response caused by natural vibration. the conversion relationship between output signal of piezoelectric ceramic plate and acoustic power of transducer was analyzed. the envelope of output piezoelectric signal was extracted in twice, and a voltage amplitude curve with sinusoidal distribution that could describe the changes acoustic power was obtained. Under different drive voltage of transducer, the maximum peak voltage of envelope curve was found respectively. Their squared values ​​were made a linear fitting with acoustic power measured by acoustic power meter, and then the proportional coe fficient of theoretical relational expression was calibrated. The experimental results are in good agreement with the theory. The relative error between calibrated theoretical acoustic power and that measured by acoustic power meter was less than 8.7%. The paper can provide a guideline for measuring acoustic power of transducer by using piezoelectric signal.