论文部分内容阅读
我厂过去在车细纱机上的锭盘外圆时,是将钻好孔的锭盘套在心子上,用木榔头敲紧,然后加工。加工完毕后,停车,旋转心子上的螺帽将锭盘推下。这样,加工一个锭盘需要花许多停车和开车的时间,影响生产效率。彭庙洪同志建议改进车制锭盘的自动卸活装置,省去了开车和停车的手续,节省了辅助时间,因且提高了生产效率。改进后的装置如附图。把三角铁⑨用两个六角螺钉固定在车头跨轮车承上。三角铁上焊有两个架子③和⑧,中间有孔,装有轴④。轴④上套有压缩弹簧⑦,和哈夫螺帽手柄⑤,以及手柄①。手柄①上装有拉簧②,拉簧
I plant in the past on the car spinning machine spindle, it is to drill a good hole in the heart of the ingot, with a wooden hammer tight, and then processing. After processing, stop, turn the nut on the heart of the mind will push down the ingot. In this way, processing an ingot takes a lot of parking and driving time, affecting production efficiency. Peng Miaomong suggested to improve the auto-unloading device of the vehicle spindle, eliminating the need for driving and parking procedures, saving auxiliary time and increasing production efficiency. The improved device is shown in the attached figure. The triangle ⑨ with two hexagonal screws fixed on the front of the cross car bearing. Triangle iron welded with two shelves ③ and ⑧, the middle hole, equipped with shaft ④. Shaft ④ sleeve with a compression spring ⑦, and Haff nut handle ⑤, and the handle ①. Handle ① is equipped with tension spring ②, tension spring