Creep behavior of SnAgCu solders with rare earth Ce doping

来源 :中国有色金属学报(英文版) | 被引量 : 0次 | 上传用户:anjialaogong
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Extensive testing was carried out to study the effects of rare earth Ce doping on the properties of SnAgCu solder alloys. The addition of 0.03% (mass fraction) rare earth Ce into SnAgCu solder may improve its mechanical properties, but slightly lower its melting temperature. The tensile creep behavior of bulk SnAgCuCe solders was reported and compared with SnAgCu solders. It is found that SnAgCuCe solders show higher creep resistance than SnAgCu alloys. Moreover, Dorn model and Garofalo model are successfully used to describe the creep behavior of SnAgCu and SnAgCuCe alloys. The parameters of the two creep constitutive equations for SnAgCu and SnAgCuCe solders are determined from separated constitutive relations and experimental results. Nonlinear least-squares fitting is selected to determine the model constants. The experimental data of the stress-creep strain rate curves are in good agreement with the theoretical ones.
其他文献
以提高夏玉米氮肥利用率、减少氮肥污染为目标,研究了不同施氮时期对夏玉米生长发育及氮肥利用率的影响.结果表明:施氮显著增加子粒产量和穗粒数,以3叶期施氮结合12展叶追氮
论述了莲雾在海南省的高产栽培技术措施.主要技术措施包括生长条件、育苗定植、整形修剪、常规肥水管理、疏花疏果、防落花落果、果实套袋、产期调节技术、病虫害防治、采收
介绍了长清某校区校园内河流水质状况,并对旱季和雨季时校内河流7个点的水质取样调查分析,动态检测了多项重要水质指标,根据现有问题提出了多项具体改进措施,对于大规模景观
目的 分析汶川地震住院伤员的伤情特点及救治,为类似自然灾害所致伤员的救治提供参考.方法 利用V3.0收集录入的四川大学华西医院和德阳市第一和第二人民医院收治的地震伤员资
2009年初全球爆发了新型甲型H1N1流感.而且至今仍在流行.虽然到目前为止该疾病病情温和,但新型甲型H1N1流感病毒传染性强,人群因对这个新型病毒缺乏免疫力而普遍易感,导致疾
A new serve plastic deformation (SPD) including initial forward extrusion and subsequent shearing process (ES) was proposed. The influence of the ES forming on
The electronic properties of sphalerite (110) surface with Zn-vacancy and S-vacancy were calculated by using density-functional theory, and the effects of vacan
On the base of nonlinear liquidus and solidus, an extended model for dendrite growth in bulk undercooled melts was developed under local non-equilibrium conditi
The accuracy of nucleation parameter is a critical factor in the simulation of microstructural evolution during dynamic recrystallization (DRX). Based on the fl
The Ti-35%Nb (mass fraction) foams were prepared by a powder metallurgy method, and the microstructure and the mechanical properties of the foams under monotoni