基于IFAHP-TOPSIS方法的控制系统执行器风险评估

来源 :动力工程学报 | 被引量 : 0次 | 上传用户：wlq808

【摘要】

：

针对控制系统执行器的各类故障,提出了改进模糊层次分析与逼近理想解排序相结合的方法(IFAHP-TOPSIS方法).采用层次分析法建立了风险评估指标体系;基于IFAHP,采用主、客观动态组合赋权法计算风险评估指标的复合权重;运用改进模糊逼近理想解排序方法(IFTOP-SIS方法)得到各故障模式的最终序位;以某燃气轮机电厂的气动执行器为例进行数值分析.结果表明:所提IFAHP-TOPSIS方法的评估结果与实际情况基本相符,与传统层次分析法结合逼近理想解排序方法(AHP-TOPSIS方法)相比,该方法能够处理

【作者】

：

张文广沈炀智李浩瀚袁桂丽

【机构】

：

华北电力大学新能源电力系统国家重点实验室,北京102206;华北电力大学控制与计算机工程学院,北京102206

【出处】

：

动力工程学报

【发表日期】

：

2021年9期

【关键词】

：

IFAHP-TOPSIS方法控制系统执行器风险评估改进模糊层次分析法复合权重

下载到本地 , 更方便阅读

下载此文赞助VIP

声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架

论文部分内容阅读

其他文献

An Asynchronous Quasi-Cloud/Edge/Client Collaborative Federated Learning Mechanism for Fault Diagnos

Although the federated learning method has the ability to balance data and protect data privacy by means of model aggregation,while the existing methods are difficult to achieve the effectiveness of centralized learning under data sharing.The existing fed

期刊

Federated learningQuasi-cloud/edge/client collaborationMulti-level confidentia

Sitting or Standing Data Acquisition Based Breast Ultrasound Computed Tomography

Ultrasound computed tomography(UCT)is a promising approach for early breast cancer screening.However, current studies which use prone posture to collect breast ultrasonic data cause four problems, a l

期刊

Data acquisitionUltrasound computed tomographyImage reconstructionSound speed

Total Ionizing Dose Effect and Failure Mechanism of Digital Signal Processor

Ionizing radiation effect and failure mechanism of Digital signal processor (DSP) is studied through test-board and automatic test equipment to find the relationship between system function failure and parameter degradation.Static bias is more sensitive t

期刊

Digital signal processorRadiation damageRadiation effect

Dynamic Multi-Task Allocation Method for Passenger Diffusion in Mobile Crowd Sensing

This paper aims to solve the problem of low efficiency,high cost and instability in opportunistic network transmission in the process of mobile group intelligence perception task allocation.Two multi-task dynamic distribution methods based on Lowest cost

期刊

Mobile crowd sensingMultitask allocationSubway passengersParticipant selectio

A 1.8-V 240-MHz 2.19-mW Four-Stage CMOS OTA with a Segmenting Frequency Compensation Technique

A four-stage Operational transconduc-tance amplifier (OTA) used in an infrared temperature sensor adopting the proposed Feed-forward Gm-stage and segmenting nested Miller compensation technique is presented.The purpose of the proposed segment compensation

期刊

Four-stage amplifiersFrequency compensationSegmenting nested Miller compensati

Popularity prediction of online video is widely used in many different scenarios.It can not only help video service providers to schedule video web sites,but also bring considerable profits on investment for both providers and advertisers if popularity of

期刊

Online video popularity predictionChannel optimizationUser behaviorMultiple l

A Novel Synchronization Method in Terahertz Large-Scale Antenna Array System

We focus on the problems of the accurate time delay estimation,the design of training pilots,and hybrid matrix optimization within the large-scale antenna array Terahertz (THz) broadband communication system.In contrast to the existing researches based on

期刊

Large-scale antenna arrayTime delay estimationConstant modulus optimizationTD

Diagnostic Classification of Lung Cancer Using Deep Transfer Learning Technology and Multi-Omics Dat

In recent years,with the increasing application of highthroughput sequencing technology,researchers have obtained and accumulated a large amount of multi-omics data,making it possible to diagnose cancer at the gene expression level.The proliferation of va

期刊

Diagnostic classificationDeep transfer learningMultiomics dataLung cancer

中速磁浮车辆设备连接箱结构设计

为满足中速磁浮车辆高度模块化和集成化的设计要求,文章提出了车辆底架设备连接箱结构及轻量化设计方案,并从可维护性的角度对结构进行优化设计.对设备连接箱结构进行有限元仿真计算,结果显示:设备连接箱静强度计算获得的最大应力为327.6 MPa,疲劳强度最大材料利用度为0.256,满足相应的静强度和疲劳标准.

期刊

中速磁浮车辆设备连接箱轻量化设计可维护性

基于有限元法的动车组行李架仿真分析与结构优化

为解决现有高速动车组行李架易破损的安全隐患,文章通过有限元计算的方法,对两种不同工况下玻璃承载面板行李架的位移和应力进行了分析,并对行李架中各个部件的应力结果进行比较,优化设计了动车组行李架.

期刊

动车组行李架有限元计算结构优化

基于IFAHP-TOPSIS方法的控制系统执行器风险评估

与本文相关的学术论文