【摘 要】
：
采用差热分析(DTA),X射线衍射分析(XRD),扫描电镜(SEM)等分析手段研究了TiO2和TiO2+ZrO2两种形核剂对Li2O-Al2O3-SiO2(LAS)系微晶玻璃的形核和晶化的影响.结果发现,样品经过
论文部分内容阅读
采用差热分析(DTA),X射线衍射分析(XRD),扫描电镜(SEM)等分析手段研究了TiO2和TiO2+ZrO2两种形核剂对Li2O-Al2O3-SiO2(LAS)系微晶玻璃的形核和晶化的影响.结果发现,样品经过不同温度的预形核处理后,采用TiO2单一形核剂,晶化峰值温度和晶化峰高度的变化较大,而采用TiO2+ZrO2复合形核剂,晶化峰值温度和晶化峰高度的变化较小.当形核时间为2h,两种形核剂样品的最佳形核温度分别为745和760.C.晶化后均可得到纳米结构的β-石英石固溶体晶相,其中采用TiO2+ZrO2复合形核剂样品的晶粒更细小.研究表明采用复合形核剂的LAS微晶玻璃的形核过程对温度的敏感性小,有利于对形核过程进行控制,同时形核效率高.
其他文献
In order to obtain fine-microstructure magnesium alloys with superior mechanical properties, AZ61 alloy was processed by friction stir processing (FSP) combined
In order to characterize the mechanics of jet breakup,the finite volume formulations were employed to solve the Navier-Stokes equations and continuity equation
The influence of electric current on Kirkendall diffusion in Zn/Cu couples was investigated. Under the action of different electric currents, the Zn/Cu diffusio
The La0.8Mg0.2Ni2.4Mn0.10Co0.55Al0.10 alloy was prepared by induction melting. The structural and morphological characterizations were performed by means of X-r
In this paper, a Cartesian grid method with cut cell has been developed to simulate mold filling of casting process. Cut cells at the cast-mold interface are ge
A new recovery technology is developed to recycle N, N-dimethyl formamide (DMF) in waste gas from wet type polyurethane synthetic leather industry. Given that t
2006～2010年,对稻田杂草稻进行了播种深度、诱发出苗和化学防除的田间试验。结果表明,在水稻移栽之前,适当增加耕翻深度和提早翻耕诱草灭草,可有效地控制其发生量;在水稻移栽
以肥肝型种鹅为研究对象,研究缩短鹅换羽期的方法,以解决种鹅季节性繁殖、年产蛋量低的技术难题.采用完全随机设计,选取24月龄青农灰鹅128只,饲喂2％氧化锌日粮,按照目标体重下
地中海贫血是一种常染色体遗传病,目前其发病机制主要集中在基因缺陷和突变方面,且这方面的研究已经趋于完善.随着表观遗传学的发展,越来越多的疾病被证实与表观遗传学有密切
为了实现番茄无损测试诊断的目标,利用叶绿素仪SPAD-502测定了番茄不同生育期成叶、新叶的SPAD读数值.结果表明:番茄无论新叶还是成叶全氮含量、叶绿素含量都与SPAD测定值有