将玻璃粉碎成微米级颗粒,作为增强材料,用硅烷偶联剂KH-550对玻璃粉进行表面处理,充填尼龙1010.制备了玻璃粉/尼龙1010复合材料,在环一块磨损试验机上研究了复合材料的摩擦学性能,使用邵氏硬度计测量了复合材料的硬度.借助SEM进行摩擦表面分析.试验结果表明:玻璃粉充填尼龙1010能降低复合材料的摩擦系数,w(玻璃粉)为25%时摩擦系数最小;w(玻璃粉)为20%时,磨损率仅为尼龙的18%.玻璃粉在一定含量的范围内能提高复合材料硬度. The glass was crushed into micron-sized particles, as a reinforcing material, with a silane coupling agent KH-550 surface treatment of the glass powder, filled with nylon 1010. Prepared glass / nylon 1010 composite ring in a wear test machine to study the composite The tribological properties of the composites were measured by using a Shore Hardness Tester.The friction surface of the composites was measured by SEM.The results show that the friction coefficient of the composites can be reduced by filling nylon 1010 with glass powder, w (glass powder) is 25% When w (glass frit) is 20%, the wear rate is only 18% of nylon.The glass powder can improve the hardness of the composite material within a certain range of content.