随着计算机的不断发展,微机上使用的各种软件占用磁盘空间不断增大,对硬盘容量的要求越来越高,配置两个硬盘的用户也越来越多。但是,由于不少硬盘没有对跨接线作出设置办法,有的虽有说明,但按说明中办法设置跳线却不能成功,以致不能顺利完成一台机器上安装两个硬盘的工作。笔者就长时间以来的使用经验,介绍给大家参考。 硬盘线缆随微机中所选用的硬盘的接口标准不同而不同。对于目前广泛使用的IDE(Integrated Device Electronic)接口的硬盘驱动器来说,其硬盘连接线 With the continuous development of computers, various types of software used on the computers occupy more and more disk space, and the requirements for the capacity of the hard disks are getting higher and higher. More and more users configure two hard disks. However, since many hard disks do not have a setting method for jumper cables, some of them have some explanations. However, setting the jumpers according to the instructions can not be successful, so that the installation of two hard disks on one machine can not be completed successfully. I use the experience over time, introduced to your reference. Hard disk cable with the selected computer hard drive interface standards vary. For the currently widely used IDE (Integrated Device Electronic) interface hard drive, the hard drive cable