【摘 要】
：
Thermal wear of cast hot-forging die steel modified by rare earths(RE) was studied and compared with commercially used die steels. The function of RE and the me
【机 构】
：
School of Materials Science & Engineering
论文部分内容阅读
Thermal wear of cast hot-forging die steel modified by rare earths(RE) was studied and compared with commercially used die steels. The function of RE and the mechanism of thermal wear of cast steel modified by RE were discussed. The results showed that with increasing content of RE, the wear rate of cast steel reduced at first and then increased. By adding 0.05%(mass fraction) RE, the cast hot-forging die steel with optimum thermal wear resistance was obtained, which was better than that of H13 and 3Cr2W8V. The large amount of coarse inclusions, (RE)2O2S, resulted from excessive RE, which obviously deteriorated thermal wear resistance. The mechanism of thermal wear of the modified cast die steel is oxidation wear and oxide fatigue delamination. The wear debris are lumps of Fe2O3 and Fe3O4.
其他文献
Y2O2S:Sm3+, Mg2+, Ti4+ phosphor was synthesized by co-precipitation method. The crystalline structure of all synthesized phosphors was investigated by XRD. The
2011年11月17日，由无锡华御信息技术有限公司主办的无锡市2011年“创新成果保护与信息安全技术”研讨会在湖滨饭店太湖厅隆重举行。
今天,爸爸妈妈带我来到“人间天堂”——杭州游玩。我们漫步在西湖边,走着走着,忽然看见一棵树下立着一块牌子,上面写着“松鼠喂食点”这五个大字。我感到十分好奇,便抬头向
The point of zero charge(PZC) of SiC nanoparticles was determined by means of standard potentiometric titration method, while the influences of the main technol
An ideal method has been established for calculating the precipitation of α2 ordered phase in near-α titanium alloys based on the theory on the critical elect
Highly conductive IrO2 thin films were prepared on Si (100) substrates by means of pulsed laser deposition technique from an iridium metal target in an oxygen a
The combined effect of phosphorus grain boundary segregation and hardness on the ductileto-brittle transition was examined for a P-doped 2.25Crl Mo steel by usi
Organic-dispersible lanthanide fluorides nanocrystals were synthesized at a large Scale using colloid-extraction method, in the presence of dialkyl-dithiophosph
Using the CALPHAD (Calculation of Phase Diagram) technique, the DyCl3-MCl (M=Na, K, Rb, Cs) systems were optimized and calculated. The modified quasi-chemical m
This paper details on the design of DVB-S2 receivers which is compliant with the broadcasting mode. Special attention is paid to the specific receiver functions