Dissociation of polar oil components in low salinity water and its impact on crude oil-brine interra

来源 :石油科学(英文版) | 被引量 : 0次 | 上传用户:wanily1123
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Despite many efforts into the study of fluids interaction in low salinity water flooding,they are not probing the basics of transport phenomena between the involved phases.This work is aimed to bring new understanding of fluid-fluid interaction during low salinity water flooding through a series of organized experiments in which a crude oil sample with known properties was kept in contact with different brine solutions of various ionic strengths.Measuring brine pH,conductivity and crude oil viscosity and density for a period of 45 days illustrates the strong effect of the contact time and ionic strength on the dissociation of polar components and physical properties of the crude oil and brine.Besides,the interfacial tension (IFT) measurements show that the interracial interactions are affected by several competitive interfacial processes.By decreasing the ionic strength of the brine,the solubility of naphthenic acids in the aqueous solution increases,and hence,the conductivity and the pH of the aqueous phase decrease.To verify this important finding,UV-Vis spectroscopy and 1H NMR analysis were also performed on aged brine samples.Notably,there is an ionic strength of brine in which the lowest IFT is observed,while the other physical properties are remained relatively unchanged.
其他文献
Deposition of fluvial sandbodies is controlled mainly by characteristics of the system,such as the rate of avulsion and aggradation of the fluvial channels and their geometry.The impact and the interaction of these parameters have not received adequate at
Dimethyl ether (DME) is a widely used industrial compound,and Shell developed a chemical EOR technique called DME-enhanced waterflood (DEW).DME is applied as a miscible solvent for EOR application to enhance the performance of conventional waterflood.When
Taking the Jurassic Sangonghe Formation in the Mosuowan-Mobei area of the Junggar Basin as an example,this paper provides a method that evaluates paleo hydrocarbon pools and predicts secondary reservoirs.Through Quantitative Grain Fluorescence (QGF) exper
The recovery factor from tight gas reservoirs is typically less than 15%,even with multistage hydraulic fracturing stimulation.Such low recovery is exacerbated in tight gas condensate reservoirs,where the depletion of gas leaves the valuable condensate be
Wellbore drilling operations frequently entail the combination of a wide range of variables.This is underpinned by the numerous factors that must be considered in order to ensure safety and productivity.The heterogeneity and sometimes unpredictable behavi
Fluidized beds are widely used in many industrial fields such as petroleum,chemical and energy.In actual industrial processes,spherical inert particles are typically added to the fluidized bed to promote fluidization of non-spherical particles.Understandi
Lower Cretaceous Shurijeh-Shatlyk Formations host some of the main reservoirs in the Kopeh Dagh-Amu Darya Basin.Exploration in this area so far has focused on the development of structural traps,but recognition of stratigraphic traps in this area is of in
Graphene oxide (GO) nano-sheets were synthesized using a modified Hummers\' method from graphite powder.The Raman spectrum of GO displayed a D-band at 1359 cm-1 and a G-band at 1594 cm-1.The ID/IG value of GO was calculated to be 0.97,suggesting the for
The influence of surface-modified silica (SiO2) nanoparticles on the stability and pore plugging properties of foams in porous media was investigated in this study.The pore plugging ability of foams was estimated from the pressure drop induced during foam
Wettability alteration of carbonate reservoirs from oil-wet to water-wet is an important method to increase the efficiency of oil recovery.Interaction between surfactants and polymers can enhance the effectiveness of surfactants in EOR applications.In thi