解放CA-10型汽车离合器分离轴承注油器由螺母和螺栓两部分组成。螺栓上安有两个黄油咀。(如图所示) 使用时,将螺母拧下,把缺油的离合器分离轴承(连同轴承座)套在螺栓上,(分离轴承靠向环形槽一边)然后把螺母拧紧在螺栓上,使分离轴承(连同轴承座)固定死,用黄油枪通过黄油咀把润滑脂注入分离轴承中。 Liberation CA-10 car clutch release bearing oiler by the nut and bolt composed of two parts. There are two butter nozzles on the bolt. (As shown), unscrew the nut and fit the loose clutch release bearing (with bearing housing) onto the bolt (with the release bearing against the side of the annular groove) and tighten the nut onto the bolt to separate Bearings (together with bearing housings) are fixed dead and the grease is injected into the release bearings with the grease gun through the grease nipple.