论文部分内容阅读
Lead-free Sn3.5Ag and Sn3.5Ag0.5Cu solder balls were reflowed by laser to form solder bumps.Shear test was performed on the solder bumps,and SEM/EDX (scanning electron microscopy/energy dispersive X-ray spectrometer) was used to analyze the formation of intermetallic compounds (IMCs) at interface region. A finite element modeling on the temperature gradient and distribution at the interface of solder bump during laser reflow process was conducted to elucidate the mechanism of the IMCs growth direction.The results show that the parameters window for laser reflow bumping of Sn3.5Ag0.5Cu was wider than that of Sn3.5Ag.The shear strength of Sn3.5Ag0.SCu solder bump was comparable to that of Sn3.5Ag solder bump,and was not affected obviously by laser power and irradiation time when appropriate parameters were used.Both laser power and heating time had a significant effect on the formation of IMCs.A continuous AuSn_4 intermetallic compound layer and some needle-like AuSn_4 were observed at the interface of solder and Au/Ni/Cu metallization layer when the laser power is small.The formation of needle-like AuSn_4 was due to temperature gradient at the interface,and the direction of temperature gradient was the preferred growth direction of AuSn_4.With increasing the laser power and heating time,the needle-like AuSn_4 IMCs dissolved into the bulk solder,and precipitated out once again during solidification along the grain boundary of the solder bump.
Lead-free Sn3.5Ag and Sn3.5Ag0.5Cu solder balls were reflowed by laser to form solder bumps. Shear test was performed on the solder bumps, and SEM / EDX (scanning electron microscopy / energy dispersive X-ray spectrometer) was used A analyze the formation of intermetallic compounds (IMCs) at interface region. A finite element modeling on the temperature gradient and distribution at the interface of solder bump during laser reflow process was conducted to elucidate the mechanism of the IMCs growth direction that. the parameters window for laser reflow bumping of Sn3.5Ag0.5Cu was wider than that of Sn3.5Ag.The shear strength of Sn3.5Ag0.SCu solder bump was comparable to that of Sn3.5Ag solder bump, and was not affected obviously by laser power and irradiation time when appropriate parameters were used.Both laser power and heating time had a significant effect on the formation of IMCs.A continuous AuSn_4 intermetallic compound layer and some needle-like AuSn_4 were observed at t he interface of solder and Au / Ni / Cu metallization layer when the laser power is small. The formation of needle-like AuSn_4 was due to temperature gradient at the interface, and the direction of temperature gradient was the preferred growth direction of AuSn_4.With increasing the laser power and heating time, the needle-like AuSn_4 IMCs dissolved into the bulk solder, and precipitated out once again during solidification along the grain boundary of the solder bump.