Photoacoustic viscoelasticity imaging dedicated to mechanical characterization of biological tissues

来源 :JournalofInnovativeOpticalHealthSciences | 被引量 : 0次 | 上传用户:ZLF308440423
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
Since changes in mechanical properties of biological tissues are often closely related to pathology, the viscoelastic properties are important physical parameters for medical diagnosis. A photoacoustic (PA) phase-resolved method for noninvasively characterizing the biological tissue viscoelasticity has been proposed by Gao et al. [G. Gao, S. Yang, D. Xing, “Viscoelasticity imaging of biological tissues with phase-resolved photoacoustic measurement,” Opt. Lett. 36, 3341–3343 (2011)]. The mathematical relationship between the PA phase delay and the viscosity–elasticity ratio has been theoretically deduced. Moreover, systems of PA viscoelasticity (PAVE) imaging including PAVE microscopy and PAVE endoscopy were developed, and high-PA-phase contrast images reflecting the tissue viscoelasticity information have been successfully achieved. The PAVE method has been developed in tumor detection, atherosclerosis characterization and related vascular endoscopy. We reviewed the development of the PAVE technique and its applications in biomedical fields. It is believed that PAVE imaging is of great potential in both biomedical applications and clinical studies.
其他文献
研究了对显示器色域及色域覆盖率参数的校准方法,分析了现有校准方法的不足,提出了一种对彩色分析仪相关色度参数的校准方法。建立了一套色域校准装置,装置主要由色域光源传递标准和分光辐射亮度计组成。色域光源传递标准由标准积分球光源和滤光片组合构成,可以校准彩色分析仪的色域相关参数。通过实验对此色域校准方法进行了验证,并得到了某发光二极管(LED)显示器的色域覆盖率测量结果。实验结果显示本校准方法能够对不同类型显示器的色域覆盖率进行测量。校准方法的色域覆盖率测量范围可达完整色域的71.0%,保证了对相关色度参数进行
A sinusoidal phase-modulating (SPM) laser diode (LD) interferometer for real-time surface profile measurement is proposed and its principle is analyzed. The phase signal of the surface profile is detected from the sinusoidal phase-modulating interference
利用π-A等温线、小角X射线衍射(SAXD)和光学测量方法研究了一种取代富勒烯(C60-Be)LB膜的结构特性。纯C60-Be分子以体相(bulk phase)的形式存在于气-液界面上。氮冠(醚)(NC)分子作为隔层材料,与C60-Be分子相混合可以制备性能优良的LB膜。π-A、吸收和小角X光衍射测量表明:这种混合膜结构的改善是由于C60-Be分子镶嵌在NC分子的双脂链之间造成的。通过测量三次谐波产生(THG)可以推出C60-Be的三阶非线性系数χ(3)=2.1×10-11 esu。
期刊
This letter presents an autofocus (AF) method to position a high-magnification microscope lens that automatically captures hundreds of images from a single moving slide. These images are taken by a mobile clinic unit in a rural location, and are later aut
期刊
期刊
We propose and demonstrate a sensitive vector twist sensor based on a small period long period fiber grating (SP-LPFG) fabricated with a femtosecond (fs) laser. The fabricated SP-LPFG is compact in size (2.8 mm) and shows strong polarization dependent pea
对于传统蚁群算法用于云计算资源分配和调度问题过程中存在的不足,提出了一种可以提高负载均衡度、缩短任务执行时间、降低任务执行成本的改进自适应蚁群算法, 改进算法以能够基于用户提交的任务求解出执行时间较短、费用较低,负载率均衡的分配方案为目标,通过CloudSim平台对传统蚁群算法、最新的AC-SFL算法、改进自适应蚁群算法进行仿真实验对比。实验数据表明,改进后的自适应蚁群算法能够快速找出最优的云计算资源调度问题的解决方案,缩短了任务完成时间,降低了执行费用,保持了整个云系统中心的负载均衡。
随着航天技术的发展,轻质反射镜的研究正朝着径厚比更大、轻量化更高的趋势发展。然而,当轻质镜面形精度峰谷(PV)值低于0.1λ时,镜面面形会明显产生波浪形的“压印效应”。重力及磨头压力所引入的“压印效应”已成为轻质结构反射镜高精度加工的技术壁垒。通过有限元Ansys软件仿真分析,采取从轻质镜结构内部施加反向压强的方法,消除轻质镜面抛光区域由于磨头压力及重力作用产生的镜面弹性形变,在满足普林斯顿去除函数方程条件下消除轻质镜面的“压印效应”。由仿真结果得到浸入充气式方法不但能消除“压印效应”,反射镜抛光面面形精