Roads with very high traffic loads in regions where soils are low in both pH and sorption capacity might be a source of percolation water loaded with heavy metals. Looking at some “worst case” scenarios, this study focused on the input of traffic related pollutants and on Pb, Cd, Cu, Zn, Ni and Cr concentrations in the soil matrix and soil solution, respectively. The analysis also included pH and electrical conductivity and at some sites DOC. The investigations were carried out on sandy soils with more or less low pH values at four motorway sites in Germany. The average of daily traffic was about 50 000 up to 90 000 vehicles. Soil pore water was collected in two soil depths and at four distances from the road. The pH in general decreased with increasing distance from the roadside. The elevated pH near the roadside was presumably caused by deposition of dust and weathering residues of the road asphalt, as well as by infiltration of salt that was used during winter time. At these road sites, increased heavy metal concentrations in the soil matrix as well as in the soil solution were found. However, the concentrations seldom exceeded reference values of the German Soil Protection Act. The soil solution concentrations tended to increase from the road edge to 10 m distance, whereas the concentration in the soil matrix decreased. Elevated DOC concentrations corresponded with elevated Cu concentrations but did not substantially change this tendency. High soil water percolation rates were found near the roads. Thus, even low metal concentrations of percolation water could yield high metal loads in a narrow area beside the road. Roads with very high traffic loads in regions where soils are low in both pH and sorption capacity might be a source of percolation water loaded with heavy metals. Looking at some “worst case ” scenarios, this study focused on the input of traffic related pollutants and on Pb, Cd, Cu, Zn, Ni and Cr concentrations in the soil matrix and soil solution, respectively. The analysis also included pH and electrical conductivity and at some sites DOC. The investigations were carried out on sandy soils with more or less low pH values ​​at four motorway sites in Germany. The average of daily traffic was about 50,000 up to 90,000 vehicles. Soil pore water was collected in two soil depths and at four distances from the road. The pH in general decreased with increasing distance from the roadside. The elevated pH near the roadside was presumably caused by deposition of dust and weathering residues of of road asphalt, as well as by infiltration of salt that was used during winter time. At these road sites, increased heavy metal concentrations in the soil matrix as well as in the soil solution were found. However, the concentrations seldom exceeded reference values ​​of the German Soil Protection Act. The soil solution concentrations tended to increase from the road edge to 10 m distance , while the concentration in the soil matrix decreased. Elevated DOC concentrations were compared with elevated Cu concentrations but did not substantially change this tendency. High soil water percolation rates were found near the roads. Thus, even low metal concentrations of percolation water could yield high metal loads in a narrow area beside the road