论文部分内容阅读
为进一步提高整个电工行业标准编写的质量,加快审批速度,1983年4月上旬在湘潭召开了第二次提高电工标准编写质量讨论会。出席会议的有来自全国36个单位,共60名代表。 自从执行《GB1.1-81准标化工作导则。编写标准的一般规定》以来,电工标准编写质量有了很大提高。 但是,由于某些单位对标准的编写质量不够重视,加上理解不一致,故在1982年上报的电工标准报批稿中,仍然存在不少问题。据统计,仅电器工业局标准化室审查过的18个标准,就提出了总共130多条意见。有些标准的质量较差,存在严重差错,需要返工,不仅造成经济损失,而且还拖延了标准的出版日期,影响其贯彻执行。 代表们认为,产生上述情况的主要原因,是起草、审查和审核标准的人员粗心大意,不够认真负责。会上,大家讨论了如何提高电工标准编写质量,加快审批进度的措施,并对有关单位的标准编写的质量,进行了一次全面检查。同时,还拟订了《审查电工标准一般要求》的讨论稿。
In order to further improve the quality of the entire electrician industry standard preparation and accelerate the speed of examination and approval, the second time in April 1983, a seminar was held in Xiangtan to improve the quality of electrician standard writing. Attending the meeting were 36 units from across the country, with a total of 60 representatives. Since the implementation of "GB1.1-81 standardization work guidelines. Since the preparation of general standards for standards, the quality of electrical standards has greatly improved. However, due to the lack of attention paid by certain organizations to the quality of standards compilation and the inconsistent understanding, there are still many problems in the IEC report submitted in 1982. According to statistics, only 18 standards reviewed by the Electric Power Industry Bureau’s standardization office have put forward a total of more than 130 opinions. Some standards are of poor quality, have serious mistakes and require rework, which not only causes economic losses, but also delays the publication date of standards and affects their implementation. Delegates believe that the main reason for the above-mentioned situation is that the personnel who drafted, reviewed and reviewed the standards were careless and not serious enough. At the meeting, everyone discussed how to improve the quality of electrician standard preparation and speed up the examination and approval process, and conducted a comprehensive inspection of the quality of standards prepared by relevant units. At the same time, a discussion draft of “General Requirements for the Examination of Electrical Engineering Standards” was also drafted.