论文部分内容阅读
细心人会发现,篮球环上的w型挂网钩根多己不存在或者残缺不全,致使球网无法挂在篮圈下面,直接影响了正常运动的开展。另一方面,这种现行的w型网钩在挂球网时比较麻烦,给体育工作者带来诸多不便。能不能想出一个新的办法来代替w型挂网钩呢?我经过长期观察和仔细琢磨,想出了一种钉孔代钩的方法。这种方法是在篮圈上每隔15厘米,从篮圈的上沿向下垂直钻一个直径为8.5毫米,深约3毫米的凹形孔。在这个凹形孔中再向下钻一个直径为5毫米的小孔,然后做一个直径为3.5毫米带锣纹的网钉。这两道工序完成之后,褂网时只需网绳从篮圈的下孔穿上,再将定网钉从球网头下面插入定网孔,这样安褂球网的全部工作就完成了。经过实验测试,这种方法完全符合比赛规则要求,不仅比W型褂网钩外形美观、漂亮,而且使用寿命长,大大减少体育工作者的劳累程度。
Careful people will find that the w-ring on the basketball ring hook has many roots or incomplete, resulting in the net can not hang under the ring, a direct impact on the normal exercise. On the other hand, this existing w-type net hook is troublesome in the net-hanging net, which brings a lot of inconvenience to the sports workers. Can you come up with a new way to replace the w-type hook hook? I after long-term observation and careful study, came up with a nail hole on behalf of the hook method. This method is every 15 cm in the ring, a vertical drill down from the rim of the ring a diameter of 8.5 mm, about 3 mm deep concave hole. Drill a further hole of 5 mm in diameter into this concave hole, and then make a 3.5 mm diameter net with gibbons. After the completion of these two procedures, the gown net just need to wear the net rope from the bottom hole of the ring, and then set the netting pin from below the ball net into the fixed net so that all the work is complete. After experimental testing, this method is fully in line with the rules of the game, not only than the W-type gape net hook appearance beautiful, beautiful, and long life, greatly reducing the degree of fatigue of sports workers.