A preliminary study of polymer inclusion membrane for lutetium(Ⅲ)separation and membrane regeneratio

来源 :稀土学报(英文版) | 被引量 : 0次 | 上传用户:heyunhu
下载到本地 , 更方便阅读
声明 : 本文档内容版权归属内容提供方 , 如果您对本文有版权争议 , 可与客服联系进行内容授权或下架
论文部分内容阅读
This paper reports on the selective transport of Lu(Ⅲ) from La(Ⅲ) and Sm(Ⅲ) through a polymer in-clusion membrane (PIM) composed of 40 wt% di(2-ethylhexyl) phosphinic acid (P227) and 60 wt%poly(vinylidene fluoride) (PVDF).Basically,the changes in surface morphology,thickness and water contact angle of this PVDF-based PIM containing P227 (P227@PVDF PIM) with different polymer con-centrations were investigated.By solvent extraction experiments,it is found that Lu(Ⅲ) can be selectively extracted from La(Ⅲ) and Sm(Ⅲ) at pH 1.5 in hydrochloric acid solution.According to this result,P227@PVDF PIM was used to selectively transport Lu(Ⅲ) from hydrochloric acid feed solution containing similar concentration of La(Ⅲ) and Sm(Ⅲ).The recovery factor of Lu(Ⅲ) is 91% after 36 h,and about 5% of Sm(Ⅲ) was also transported through the PIM.The concentration of La(Ⅲ) in the feed solution and the stripping solution does not change.Furthermore,to overcome the ubiquitous decline of transport effi-ciency caused by the loss of carrier or the damage of membrane structure after long-term use of PIMs,a process for regenerating PIMs was first proposed and implemented.By comparison of the regenerated PIM with the normal PIM,there is almost no difference in the SEM image,ATR-FTIR spectrum and Lu(Ⅲ)transport efficiency.It is expected that P227@PVDF PIMs have the potential to be applied to the grouped separation of rare earth elements (REEs),and this study also can be as an inspiration for the further study on the PIMs regeneration process.
其他文献
本文采用射频磁控溅射法在Si(100)和石英衬底制备纯 β-Ga2O3和不同浓度的Si掺杂β-Ga2O3薄膜,并且研究Si掺杂对β-Ga2O3薄膜结构、表面形貌和光学性质的影响.X射线衍射(XRD)
Rare earths (REs) play a key role in distorting spinel structure by creating some defects at the lattice sites and make them suitable for magnetodielectric appl
本文介绍了一种坩埚冷却供水闭式循环监控系统,以西门子S7-1200系列PLC作为控制核心,WinCC 7.3组态软件作为人机界面,目的是为坩埚冷却供水闭式循环系统提供一种安全可靠的监
分析凝缩性物质的抑霜机制,搭建乙醇喷射换热性能可视化试验系统,观测乙醇喷射比(乙醇与空气中水蒸气质量比)和换热器管壁温度对换热器结霜特性的影响,分析传热系数、管外侧压损、霜层厚度等随乙醇喷射比的变化,得到不同条件下乙醇对结霜过程的影响规律。结果表明,当载冷剂进口温度为77 K,乙醇喷射比为0.6时,换热器传热系数是未喷射乙醇时的2倍,在30 s时霜层厚度仅为未喷射乙醇时的1/10;当载冷剂进口温度为240 K,乙醇喷射比分别为0.1和0.2时,换热器传热系数与未喷射乙醇相比分别提升30%和60%;当载冷剂
The behavior of room temperature phosphorescence quenching and fluorescence enhancing of gado-linium labeled sinoporphyrin sodium (Gd-DVDMS) in the aqueous solu
为满足家用空调器压缩机变频模块风冷直肋式散热器的散热要求,并实现轻量化、小量化,本文对该散热器进行参数化设计,通过双目标(热源温度和散热器质量)寻优,从1200个方案中筛选出最优方案,并进行试验验证。结果表明,2.6 kW空调器压缩机变频模块散热器质量仅219 g,较原方案降低95 g,且热源温度下降约7.5℃,轻量化效果显著。
在模拟水(地)源热泵机组出厂运输过程中多次出现压缩机固定螺栓断裂的问题,本文通过对螺栓设计强度、材质、安装工艺、载荷分布等方面进行排查,并结合整机结构做受力仿真分析,确定机组结构设计不合理为螺栓断裂根本原因。通过改进冷凝器底部支座与机组底座的结构,进行有限元分析及运输环境振动试验,结果表明机组结构完好,未发生压缩机螺栓断裂问题,机组结构整改合格。
相关研究表明,暖通空调系统的能耗约占建筑总能耗的50%[1]。随着城市土地资源日益紧张,建筑体量较大的综合体建筑在城市化进程中逐渐增多,空调能耗也相应变大,降低此类建筑的空调能耗变得至关重要。而合理的暖通空调系统设计方案是降低空调能耗,节约经济成本,建设可持续发展的绿色建筑的关键环节。如某医院的节能改造[2],通过对主机、水泵合理的选型和运行调整,空调系统改造后的节能率可达32%;再如某科技馆[3],采用过渡季全新风、冷却塔免费供冷等节能措施,系统年节能率可达25.72%,由此可见合理的空调系统设计的重要
研究了真空涂层设备控制系统和工艺安全要求的特性,提出以IEC 62061标准完成设备的SIL评估、SIS设计和SIL验证,完成了整套SIS的集成和应用研发,并实现了SIS与总控系统的信息
多联机系统在自由组合时,由于各室外机性能参数存在差异,如何根据室内需求负荷发挥各室外机最佳能效比是节能的关键。本文根据各室外机不同工况下能效比参数和室内负荷,对比切换前后能效比计算值,选择最佳室外机组合,确定各室外机的压缩机运行频率。通过试验测试数据对比分析,整个系统处在最佳能效比状态下可实现15%节能运行。