我厂的一台3吨模锻锤由于没有装模具的专用设备,过去都是用在一端配置适当重量的“秤杆”将模具送入锻锤的安装空间,这种装模方法很化时间,而且工人的劳动强度也大。我们走访了一些工厂的模锻车间,大部分都是这样装模的。也有将模具吊在较长的钢丝绳上,将它摆进装模空间,这个办法既不可靠,也不安全。为了改变装模的落后面貌,我厂模锻组的 I plant a 3-ton die forging hammer mold equipment because there is no special equipment, the past are used at one end of the configuration of the appropriate weight of the “weigh bar” to the mold into the installation space forging hammer, this method of loading is very time, And workers are also labor-intensive. We visited a number of factory forging workshop, most of them are so modeled. There is also a mold hanging on a longer rope, put it into the mold space, this approach is neither reliable nor safe. In order to change the backward appearance of the mold, I plant forging group