【摘 要】
：
A series of thermal compressing tests of Mg-6Zn-0.5Zr and Mg-6Zn-0.5Zr-1Er alloys were performed on a Gleeble-1500D thermal simulator. The microstructures of th
【机 构】
：
College of Science,The Key Laboratory of Electromagnetic Processing of Materials
论文部分内容阅读
A series of thermal compressing tests of Mg-6Zn-0.5Zr and Mg-6Zn-0.5Zr-1Er alloys were performed on a Gleeble-1500D thermal simulator. The microstructures of thermal compressed Mg-6Zn-0.5Zr and Mg-6Zn-0.5Zr-1Er alloys were determined by optical microscopy, transmission electron microscopy and X-ray diffractometry. The results show that Mg-6Zn-0.5Zr alloy mainly consists of α-Mg and MgZn2 phase, while Mg-6Zn-0.5Zr-1Er alloy comprises α-Mg phase, coarse Mg3Zn4Er2 eutectic, rod-liked Mg3Zn4Er2 precipitated phase, fine I phase particle (Mg3Zn6Er, icosahedral quasicrystal structure). The peak flow stress becomes larger with increasing strain rate and erbium addition at the same temperature, and gets smaller with increasing deformation temperature at the same strain rate. The deformation activation energy increases with increasing temperature, strain rate and erbium addition. In addition, it is observed that the growth of dynamic recrystallization (DRX) grains of Mg-6Zn-0.5Zr-1Er alloy was markedly suppressed due to the pinning effect of fine I phase and Mg3Zn4Er2 phase during thermal compression.
其他文献
Ultra-fine Ce:YAG phosphors were prepared by homogeneous precipitation under microwave irradiation method. The formation of Ce:YAG was investigated by means of
The influence of polypropylene fiber on the flexural fatigue performance of high- strength concrete (HSC), which could be used as cover of reinforcement of segm
The X-ray diffractive technology was adopted for tentative study of plastic bonded explosive. The datum of some new diffractive peaks in standard PDF cards were
In this paper, we propose a novel optimal quality adaptation algorithm for MPEG-4 fine granular scalability (FGS)stream over wired network. Our algorithm can ma
The nanocomposite materials containing rare earths, titanium dioxide and clay (RE/TiO2/Clay) were characterized and tested for the photocatalytic decomposition
ZrO2 precursor powders containing 3% Y2O3 were prepared via a single emulsion processing route and a double emulsion processing route. In both routes xylol was
Melt-spun Nd8Fe78B6Co4 magnetic powders and their bonded magnets were prepared with the optimization of compositions and preparation techniques. The microstruct
Hypereutectic Al-Si alloy tubes were produced by centrifugal casting process using an electromagnetic field (EMF). A gradient distribution of the primary Si par
Three novel dielectric ceramics Ba5LnZnNb9O30 (Ln= La,Nd and Sm) were synthesized and characterized in the BaO-Ln2O3-ZnO-Nb2O5 quaternary system,which formed th
A new technique was proposed to determine the coefficient of thermal expansion (CTE) of thin films at low temperature. Different pre-stress could be applied and