论文部分内容阅读
我们在八台机床上采用二硫化钼粉剂*作为润滑剂,来改善传动部件及导轨的润滑状况,消除工作台爬行和噪音,经过长期试验,效果良好。喷涂前,先擦净被润滑表面。把二硫化钼粉剂加入25倍(重量比)的无水酒精中,稀释成液态,然后均匀地喷涂在润滑表面上(也可用干净的毛刷涂上一层),就可开车使用。这种方法,既经济又简便,效果也很好(见附表),同时,使用期限长,并且不会流失。对立导轨,垂直丝杠螺母等注油容易流失的地方,用这种固
We use eight molybdenum disulfide powder * as a lubricant on eight machine tools to improve the lubrication of transmission components and guide rails, eliminating creep and noise on the workbench and performing good results after long-term testing. Before spraying, wipe the surface being lubricated. Add molybdenum disulfide powder to 25 times (weight ratio) of anhydrous alcohol, dilute into a liquid state, and then spray evenly on the lubrication surface (you can also use a clean brush coated layer), you can drive. This method, both economical and simple, the effect is also very good (see the attached table), at the same time, the service life is long, and will not be lost. Opposing rail, vertical screw nut grease easily lost place, with this solid