Two experimental techniques have been used to quantify the atomic oxygen density in the case of hot air plasma generated by a microwave(MW) resonant cavity.The latter operates at a frequency of 2.45 GHz inside a cell of gas conditioning at a pressure of 600 mbar,an injected air flow of 12 L/min and an input MW power of 1 k W.The first technique is based on the standard two photon absorption laser induced fluorescence(TALIF) using xenon for calibration but applied for the first time in the present post discharge hot air plasma column having a temperature of about4500 K near the axis of the nozzle.The second diagnostic technique is an actinometry method based on optical emission spectroscopy(OES).In this case,we compared the spectra intensities of a specific atomic oxygen line(844 nm) and the closest wavelength xenon line(823 nm).The two lines need to be collected under absolutely the same spectroscopic parameters.The xenon emission is due to the addition of a small proportion of xenon(1% Xe) of this chemically inert gas inside the air while a further small quantity of H_2(2%) is also added in the mixture in order to collect OH(AX) and NH(A-X) spectra without noise.The latter molecular spectra are required to estimate gas and excitation temperatures.Optical emission spectroscopy measurements,at for instance the position z=12 mm on the axis plasma column that leads to a gas measured temperature equal to 3500 K,an excitation temperature of about 9500 K and an atomic oxygen density 2.09×10~(17)±0.2×10~(17)cm~(-3).This is in very good agreement with the TALIF measurement,which is equal to2.0×10~(17)cm~(-3). Two experimental techniques have been used to quantify the atomic oxygen density in the case of hot air plasma generated by a microwave (MW) resonant cavity. The latter operates at a frequency of 2.45 GHz inside a cell of gas conditioning at a pressure of 600 mbar , an injected air flow of 12 L / min and an input MW power of 1 k W. The first technique is based on the standard two photon absorption laser induced fluorescence (TALIF) using xenon for calibration but applied for the first time in the present post discharge hot air plasma column having a temperature of about 4500 K near the axis of the nozzle. The second diagnostic technique is an actinometry method based on optical emission spectroscopy (OES) .In this case, we compared the spectra intensities of a specific atomic oxygen line (844 nm) and the closest wavelength line (823 nm). The two lines need to be collected under absolutely the same spectroscopic parameters. The xenon emission is due to the addition of a small proportion of xenon (1 % Xe) of this chemically inert gas inside the air while a further small quantity of H_2 (2%) is also added in the mixture to order to collect OH (AX) and NH (AX) spectra without noise. The latter molecular spectra are required to estimate gas and animated temperatures. Optical emission spectroscopy measurements, at for instance the position z = 12 mm on the axis plasma column that leads to a gas measured temperature equal to 3500 K, an excitation temperature of about 9500 K and an atomic oxygen density 2.09 × 10 ~ (17) ± 0.2 × 10 ~ (17) cm ~ (-3). This is in very good agreement with the TALIF measurement, which is equal to 2.0 × 10 ~ (17) cm ~ 3).